Abstract:Various aspects of the bacteriology of inedible rendering have been investigated in order to establish a solid basis for future decisions concerning an up-to-date and flexible legislation on rendering. Thermal death (TD)-graphs for spores of B. cereus and Cl. perfrigens, PA 3679 (Fig. 3), and heat transmission equations for animal tissues have been determined. By using the heat transmission data for bones and the TD graphs for the spores it is possible to predict the decimal reductions of spores in the centre of the largest pieces present during a given rendering process, thus establishing conditions for bacteriological safe processes. The calculations show that predrying for 45 min followed by cooking at 125 degrees C for 15 min and final drying ensures destruction of non-sporeforming bacteria and Bacillus anthracis spores even in the centre of 70 mm bone particles while heat resistant spores of clostridia are virtually unaffected. By reducing the particle size to less than 40 mm, the same process will result in a reasonable reduction of heat resistant clostridia spores, too (Table 4). In order to verify such theoretically calculated effects a new technique has been developed in which steel tubes containing a paste inoculated with spores were inserted in bones. These were treated in a cooker, were caught during discharge and examined. The results confirmed the calculations (Table 5). Most modern rendering systems (Carver-Greenfield, Stork-Duke, Wet Pressing) are continuous without pressure cooking and a common feature is a fine mincing minimizing the problem of heat penetration. In order to obtain information regarding the thermal sterilizing effect in such systems investigations were made in a pilot cooker using inoculated meat-and-bone meal mixed with water and/or fat. Regardless of whether fat was added or not sterility was found for samples containing water when the temperature during drying reached 110-120 degrees C, whereas cooking in fat only drastically increased the heat resistance of spores of both strains. Sterility was only obtained at temperatures of the order of 140 degrees C, a fact of minor importance for rendering, where thermal treatment usually takes place with moisture present. The decimal reductions actually found were compared to calculated ones and the former were all substantially higher than the latter (Table 6). Thorough investigation of sterilization in the wet pressing system has confirmed the conclusion that inactivation of pathogenic microorganisms during drying is obtained when temperatures reach 110 degrees C (Table 7 and 8).(ABSTRACT TRUNCATED AT 400 WORDS)

REFINEMENT OF STERILIZATION REGIMES OF HETEROGENEOUS VEGETABLE PRODUCTS IN DEPENDENCE FROM VALUE pH

Compression Heating and Temperature Control for High-Pressure Destruction of Bacterial Spores: An Experimental Method for Kinetics Evaluation

Microbial Detoxification of Residual Pesticides in Fermented Foods: Current Status and Prospects

Combined Effect of High Pressure and Slightly Acidic Electrolyzed Water on Sterilization of Fresh-cut Fruits and Vegetables

Research progress in the optimization of thermal sterilization in canned food

Contamination pathways of spore-forming bacteria in a vegetable cannery

Impact of sporulation temperature on germination of Bacillus subtilis spores under optimal and adverse environmental conditions

Effects of Sterilization Treatments on the Analysis of TOC in Water Samples.

Investigation of the migration of the least heating zone of clarified apple juice during heat treatment

Gentle Sterilization of Carrot-Based Purees by High-Pressure Thermal Sterilization and Ohmic Heating and Influence on Food Processing Contaminants and Quality Attributes

Application of Modern Polymer Packaging for Food

Optimizing the sterilization process of canned yellowfin tuna through time and temperature combination

Influence of prior pH and thermal stresses on thermal tolerance of foodborne pathogens

Recent Progress in the Synergistic Bactericidal Effect of High Pressure and Temperature Processing in Fruits and Vegetables and Related Kinetics

Method to Study the Survival Abilities of Foodborne Bacterial Pathogens Under Food Processing Conditions

Some microbiological aspects of inedible rendering processes

Study on sterilization effect of Staphylococcus epidermidis and Lactobacillus brevis disinfection treatments

Verification the detection method Staphylocoscus aureus from food products

Thermal stability of a functional probiotic food ingredient based on encapsulated microorganisms Lactobacillus plantarum SP-A3

Modification of Biotesting-Based Fermented Dairy Product Design for Curd and Curd Products

Veterinary and sanitary assessment and disinfection of refrigerator chambers of meat processing enterprises