Abstract:This study analyzes the combustion of pellets and briquettes made of plant biomass in low-power heating devices powered periodically with fuel being placed on the grate, as well as after modification using an automatic fuel feeding system in the gutter burner. The use of herbaceous biomass in the form of pellets in low-power heating devices with automatic fuel feeding and combustion in a gutter burner is not widely promoted and popular. Therefore, this study used four types of herbaceous waste biomass (wheat straw, rye straw, oat straw and hay) and one type of woody waste biomass (birch sawdust) for testing. The basic chemical characteristics were determined for the raw materials. After appropriate preparation, the selected starting materials were subjected to briquetting and pelleting processes. Selected physical properties were also determined for the obtained biofuels. Biofuels made from birch sawdust had the lowest heat value (16.34 MJ·kg−1), although biofuels made from wheat, rye and hay straw had a slightly lower calorific value, respectively: 16.29; 16.28 and 16.26 MJ·kg−1. However, the calorific value of oat straw biofuels was only 15.47 MJ kg−1. Moreover, the ash content for herbaceous biomass was 2–4 times higher than for woody biomass. Similar differences between herbaceous and woody biomass were also observed for the nitrogen and sulfur content. To burn the prepared biofuels, a domestic grate-fired biomass boiler was used, periodically fed with portions of fuel in the form of pellets or briquettes (type A tests), which was then modified with a gutter burner enabling the automatic feeding of fuel in the form of pellets (type B tests). During the combustion tests with simultaneous timing, the concentration of CO2, CO, NO and SO2 in the exhaust gases was examined and the temperature of the supplied air and exhaust gases was measured. The stack loss (qA), combustion efficiency index (CEI) and toxicity index (TI) were also calculated. The research shows that the use of automatic fuel feeding stabilizes the combustion process. The combustion process is balanced between herbaceous and woody biomass biofuels. Disparities in CO2, CO and Tgas emissions are decreasing. However, during type B tests, an increase in NO emissions is observed. At the same time, the research conducted indicates that the combustion of herbaceous biomass pellets with their automatic feeding into the combustion chamber is characterized by an increase in combustion efficiency, indicating that when the combustion process is automated, they are a good replacement for wood biofuels—both pellets and briquettes.

Development and Performance of a Multi-Fuel Residential Boiler Burning Agricultural Residues

Technical and Economic Feasibility of Combusting Biocarbon in Small Scale Pellet Boilers

Numerical Study of Co-Firing Lignite and Agricultural Biomass in Utility Boiler under Variable Operation Conditions

The combustion of torrefied biomass in commercial-scale domestic boilers

Experimental Investigation and Mathematical Modelling of Wood Combustion in A Moving Grate Boiler

Evaluating the Impact of Wood Sawdust and Peanut Shell Mixing Ratio on Co-Combustion Performance

Experimental Combustion of Different Biomass Wastes, Coals and Two Fuel Mixtures on a Fire Bench

Combustion of Biomass Based Pellets With Pyrolysis Bio-Oils

Development of an efficient method to blend forest biomass with agricultural residue to produce fuel pellets with improved mechanical properties

Combustion performance and emissions from torrefied and water washed biomass using a kg-scale burner

Comparison of Emission Characteristics of Small-Scale Heating Systems Using Biomass Instead of Coal

Size-dependent characterization of particles from domestic boilers fuelled with exhausted olive cake and almond shells

Comprehensive Experimental Study of Biomass Conversion Behavior: From Particle Phenomena to Reactor Scale

The energy and ecological performance of the hot water boiler burning linden bark and wood briquettes

Biomass Combustion in the Helically Coiled Domestic Boiler Combined with the Equilibrium/Chemical Kinetics CFD Approach

Combustion Efficiency of Various Forms of Solid Biofuels in Terms of Changes in the Method of Fuel Feeding into the Combustion Chamber

Performance Evaluation of Two 25 Kw Residential Wood Pellet Boiler Heating Systems

Combustion Characteristics and Working Condition Optimization for Wood and Herb Biomass

230 kW Biomass Hot Water Boiler Developed

Improving the Fuel Combustion Quality Control System in Medium Power Boilers

Emission of Harmful Substances from the Combustion of Wood Pellets in a Low-Temperature Burner with Air Gradation: Research and Analysis of a Technical Problem