Abstract:The IEEE 802.11 wireless local-area network (WLAN) has been deployed around the globe as a major Internet access medium due to its low cost and high flexibility and capacity. Unfortunately, dense wireless networks can suffer from poor performance due to high levels of radio interference resulting from adjoining access points (APs). To address this problem, we studied the AP transmission power optimization method, which selects the maximum or minimum power supplied to each AP so that the average signal-to-interference ratio (SIR) among the concurrently communicating APs is maximized.However, this method requires measurements of receiving signal strength (RSS) under all the possible combinations of powers. It may need intolerable loads and time as the number of APs increases. It also only considers the use of channel bonding (CB), although non-CB sometimes achieves higher performance under high levels of interference. In this paper, we present an AP interface setup optimization method using the throughput estimation model for concurrently communicating APs. The proposed method selects CB or non-CB in addition to the maximum or minimum power for each AP. This model approach avoids expensive costs of RSS measurements under a number of combinations. To estimate the RSS at an AP from another AP or a host, the model needs the distance and the obstacles between them, such as walls. Then, by calculating the estimated RSS with the model and calculating the SIR from them, the AP interface setups for a lot of APs in a large-scale wireless network can be optimized on a computer in a very short time. For evaluation, we conducted extensive experiments using Raspberry Pi for APs and Linux PCs for hosts under 12 network topologies in three buildings at Okayama University, Japan, and Jatiya Kabi Kazi Nazrul Islam University, Bangladesh. The results confirm that the proposed method selects the best AP interface setup with the highest total throughput in any topology.

An Actual Stadium Verification of WLAN Using a Distributed Smart Antenna System (D-SAS)

Performance Analysis of a New Topology of Distributed Antenna Systems

Link-Level Analysis of a Multiservice Indoor Distributed Antenna System [wireless Corner]

Spatial Reuse in IEEE 802.11bn Coordinated Multi-AP WLANs: A Throughput Analysis

Reconfigurable Distributed Antennas and Reflecting Surface: A New Architecture for Wireless Communications

Measurement-based Delay Spread Analysis of Indoor Distributed Antenna Systems

Antenna Location Design for Distributed-Antenna Based Secondary Systems

A Multi-AP Architecture for High-Density WLANs: Protocol Design and Experimental Evaluation

Energy Efficient Multi-Active/Multi-Passive Antenna Arrays for Portable Access Points

Smart Antenna Technology for Wireless LAN Systems

An Interface Setup Optimization Method Using a Throughput Estimation Model for Concurrently Communicating Access Points in a Wireless Local Area Network

On stochastic geometry modeling of WLAN capacity with dynamic sensitive control

Sam: Enabling Practical Spatial Multiple Access In Wireless Lan

Distributed Antenna Systems With Power Adjusted Beam Switching

Transmit Antenna Selection with Power and Rate Allocation for Spatial Multiplexing in Distributed Antenna Systems

SES: Stable and Efficient Solution for Rate Control and Spectrum Allocation in Wireless LANs

Power coverage and fading characteristics of indoor distributed antenna systems

Meta-Wall: Intelligent Omni-Surfaces Aided Multi-Cell MIMO Communications

Artificial Noise Assisted Secure Transmission for Distributed Antenna Systems.

Channel Measurements and Capacity Analysis of Indoor Distributed Antenna System

Enhanced CSMA/CA Protocol Design for Integrated Data and Energy Transfer in WLANs