Improvement of microstructure and mechanical properties of laser welded Al-Si coated 22MnB5 steel joints by austenitic element copper
Youping Zhang,Youqiong Qin,Tao Chen,Chenduo Ji
DOI: https://doi.org/10.1016/j.mtcomm.2024.108989
IF: 3.8
2024-04-26
Materials Today Communications
Abstract:In this experiment, the effects of different copper foil thicknesses on the morphology, structure, and mechanical properties of laser lap welded 22MnB5 steel joints were studied. The aim was to reduce the damage of Al-Si coating and increase the mechanical properties of welded joints. As the thickness of copper foil increases from 0 to 100μm, there was a gradual decrease in the presence of δ-ferrite in the fusion zone (FZ) and fusion boundary (FB), while the copper-rich content of lath martensite (LM) gradually increased. The reason was that Cu is an austenite element which can expand the γ phase area and play a stabilizing and strengthening role. The result of JmatPro software can support it. It found peritectic reaction (L+δ→γ) range expanded from 1414 to 1422°C to 1436–1453°C which led to more γ phases formed during the solid-state phase transition (δ→γ) at high temperature. Based on this phenomenon, as the copper foil increased (0–100μm), the joint tensile strength increased from 361 MPa to 706 MPa. However, after adding too much copper foil (200μm), the microstructure of FZ varied to a copper-rich phase (ε-Cu) with low hardness and brittleness which adhered to the martensite grain boundaries and reduced the bonding force of the crystal boundaries, so the the mechanical properties of the weld joint seriously reduced (232 MPa). When the copper foil was thin or non-existent (0–30μm), there was still more delta ferrite in FB (low strength and brittle), and the fracture type of the joint mainly appeared as a cleavage fracture. When adding 100μm copper foil, the fracture expressed ductile fracture due to the interfacial fracture due to the lack of δ-ferrite in FB. If the thickness of Cu increased to 200μm, the fracture changed back to FB which expressed a quasi-cleavage fracture.
materials science, multidisciplinary