Abstract:This paper presents a comparison between two design methodologies applied to permanent magnet synchronous machines for hybrid and electric vehicles (HEVs and EVs). Both methodologies are based on 2D finite element models and coupled to a genetic algorithm to optimize complex non-linear geometries such as multi-layer permanent magnet machines. To reduce the computation duration to evaluate Induced Voltage and Iron Losses for a given electrical machine configuration, a new methodology based on geometrical symmetries and magnetic symmetries are used and is detailed. Two electromagnetic models have been developed and used in the design stage. The first model was the stepped rotor position finite element analysis called abc model which considered the spatial harmonics without any approximation of the waveform of flux linkage inside the stator, and the second model was based on a fixed rotor position called dq model, with the approximation that the waveform of flux linkage inside the stator was sinuous. These two methodologies are applied to the design of a synchronous machine for HEVs and EVs applications. Design results and performances are analyzed, and the advantages and drawbacks of each methodology are presented. It was found that the dq model is at least 5 times faster than the abc model with high precision for both the torque and induce voltage evaluation in most cases. However, it is not the case for the iron losses computation. The iron loss model based on dq model is less accurate than the abc model with a relative deviation from the abc model greater than 70% at high control angle. The choice of the electromagnetic model during the optimization process will therefore influence the geometry and the performances of the obtained electrical machine after the optimization.

LightGBM Technique and Differential Evolution Algorithm-Based Multi-Objective Optimization Design of DS-APMM

Optimization and Comparison of Dual-Armature Flux-Switching Permanent Magnet Machines with Different Stator Core Shapes

Multi-Structural Optimization of Bearingless Permanent Magnet Slice Motor Based on Virtual Prototype in Ansoft Maxwell

Comparison of Dual-Stator Permanent Magnet Machines with Different Rotor Topologies

Optimization Design of an Interior Permanent-Magnet Synchronous Machine for a Hybrid Hydraulic Excavator

Multi-objective Optimization Design of Hybrid Excitation Double Stator Permanent Magnet Synchronous Machine

A Multi-Objective Topology Optimization Methodology and Its Application to Electromagnetic Actuator Designs

The Application of Differential Evolution in Permanent Magnet Synchronous Motor Optimal Design

A Hybrid Multi-Objective Optimization Method and Its Application to Electromagnetic Device Designs

Nonlinear Analytical Model-Embedded Optimal Design for ER-PMSM

Kriging-Assisted Multiobjective Optimization of Embedded Magnetic Encoder in PM Synchronous Machines

Multi-Objective Optimal Design of High-Speed Surface-Mounted Permanent Magnet Synchronous Motor for Magnetically Levitated Flywheel Energy Storage System

Sequential Subspace Optimization Design of a Dual Three-Phase Permanent Magnet Synchronous Hub Motor Based on NSGA III

Comparative Study of Biased Flux PM Machines Having Different Stator Core Segments and Armature Winding Configurations

Comparative Study and Design Optimization of a Dual-Mechanical-Port Electric Machine for Hybrid Electric Vehicle Applications

A Two-Stage Multi-Objective Design Optimization Model for a 6 MW Direct-Drive Permanent Magnet Synchronous Generator

Multi-Objective Optimization Design of the External Rotor Permanent Magnet-Assisted Synchronous Reluctance Motor Based on the Composite Algorithm

Multi-Objective Optimization of Electrical Machines using a Hybrid Data-and Physics-Driven Approach

Multi-objective optimum design of five-phase squirrel cage induction motor by differential evolution algorithm

Design Optimization of Multi-Layer Permanent Magnet Synchronous Machines for Electric Vehicle Applications

Multi-objective Optimization Design of External Rotor Permanent Magnet Machine for In-wheel Applications