Abstract:Despite the many articles about activated carbon with different precursors in adsorption process, no in-depth research has been carried out to understand the causes of the difference in surface adsorption characteristics of activated carbon with different precursors and different activation processes. In this work, the ability of two active carbon adsorbents made of walnut shell and peach kernel by two chemical and physical methods (totally 4 different types of activated carbon) in treatment of oily wastewater including diesel, gasoline, used oil or engine lubricant has been compared. The results show that the chemical activated peach carbon active with 97% hardness has provided the highest hardness and physical activated walnut carbon active has obtained the lowest hardness value (87%). It is also found that peach activated carbon has a higher iodine number than walnut activated carbon, and this amount can be increased using chemical methods; Therefore, the highest amount of Iodine Number is related to Peach activated carbon that is made by chemical method (1230 mg/g), and the lowest amount of iodine number is seen in walnut activated carbon that is made by physical method (1020 mg/g). moreover, the pore diameter of physical activated carbon is lower than chemical activated carbon in all cases. So that the pore diameter of chemical activated peach carbon active is equal to 22.08 μm and the measured pore diameter of physical activated peach carbon active is equal to 20.42 μm. These values for walnut are obtained as 22.74 μm and 21.86 μm, respectively. Furthermore, the temperature and pH effects on the adsorption of different synthesized oily wastewater was studied and it was found that a decrease in adsorption can be seen with an increase in temperature or decreasing the pH value, which can be referred to this fact that the process of adsorption is an exothermic process. Finally, to analyze the compatibility of adsorption isotherms with experimental data and to predict the adsorption process, three different isotherms named Langmuir, Temkin, and Freundlich isotherms were applied and their parameters were correlated. The correlation results show that the Langmuir isotherm had the best correlation in all cases compared to the Freundlich and Temkin isotherms, based on the correlation coefficient, and the calculated R 2 values which was greater than 0.99 in all the studied cases.

Mass Transfer Mechanism and Equilibrium Modelling of Hydroxytyrosol Adsorption on Olive Pit–Derived Activated Carbon

Optimization of preparation conditions of a novel low-cost natural bio-sorbent from olive pomace and column adsorption processes on the removal of phenolic compounds from olive oil mill wastewater

Activated-hydrochar derived from olive mill wastes for the removal of phenolic compounds from olive mill wastewater

CO 2 Capture from Porous Carbons Developed from Olive Pruning Agro-Industrial Residue

Cooperative Pollutant Adsorption and Persulfate-Driven Oxidation on Hierarchically-Ordered Porous Carbon.

Synergetic effect between photocatalytic degradation and adsorption processes on the removal of phenolic compounds from olive mill wastewater

Preparation of Activated Carbon Derived from Jordanian Olive Cake and Functionalized with Cu/Cu2O/CuO for Adsorption of Phenolic Compounds from Olive Mill Wastewater

A new combined technology: Macroporous adsorption resin and high speed counter current chromatography for hydroxytyrosol separation from olive leaf enzymatic hydrolysate

Fitting Biochars and Activated Carbons from Residues of the Olive Oil Industry as Supports of Fe- Catalysts for the Heterogeneous Fenton-Like Treatment of Simulated Olive Mill Wastewater

Removal of pollutants from aqueous product of Co-hydrothermal liquefaction: Adsorption and isotherm studies

Enzymatic synthesis of Hydroxytyrosol from Oleuropein for valorization of an agricultural waste

Optimizing filters of activated carbons obtained from biomass residues for ethylene removal in agro-food industry devices

Comprehensive study of valorisation of exhausted olive pomace through the preparation of highly porous activated carbons

Kinetic modeling of the removal of phenolic compounds from olive mill wastewater by hierarchical zeolite/carbon nanotubes: Isotherm, kinetics, and thermodynamic

Adsorption Removal of Glycidyl Esters from Palm Oil and Oil Model Solution by Using Acid-Washed Oil Palm Wood-Based Activated Carbon: Kinetic and Mechanism Study.

Experimental and Theoretical Investigation of Olive Mill Solid Waste Biochar for Vanillic Acid Adsorption Using DFT/B3LYP Analysis

Thermodynamic and structural investigation of oily wastewater treatment using peach kernel and walnut shell based activated carbon

Preparation and characterization of activated carbons from Lemon Pulp for oxytetracycline removal

A sustainable and highly efficient fossil-free carbon from olive stones for emerging contaminants removal from different water matrices

On the Valorization of Olive Oil Pomace: A Sustainable Approach for Methylene Blue Removal from Aqueous Media

Valorization of Olive Leaf Polyphenols by Green Extraction and Selective Adsorption on Biochar Derived from Grapevine Pruning Residues