Abstract:Abstract The heat storage technology can improve the performance of a solar thermal utilization system effectively. This work studied the effect of phase-change materials (PCMs) on thermal stratification in a heat storage tank. A 60 l sodium acetate trihydrate heat storage tank with 331.15 K phase-change temperature was designed and fabricated. A mathematical model was built to simulate the discharge process in the water tank, and the temperature distribution during the discharge process was obtained. The computational fluid dynamics model was verified by the experimental data. Furthermore, the Ri, the fill efficiency, and the MIX number were adopted to extensively analyze the performance of a heat storage tank with different positions of PCMs with the variation of flow rates. The results indicated that the distance between the isothermal surfaces of 303.15 K and 348.15 K in PCM1, PCM2, PCM3, and PCM4 were 11.75 cm, 11.13 cm, 10.52 cm, and 9.28 cm, respectively, with 9 l/min of flow velocity when t* = 0.7, showing that the thermal stratification was improved as the position of the PCMs got closer to the inlet. The PCMs’ half-life (the liquefaction rate reached 50%) was prolonged as the inlet flow rates increased. As the flow rate increased from 1 l/min to 5 l/min, the half-life of PCM4 delayed from a dimensionless time of 0.5 to a dimensionless time of 0.9. Moreover, when the flow velocity was 9 L/min, the liquefaction rate of PCM4 remained at 1. The calculated values of fill efficiency and Richardson number were higher than the experimental data slightly, while the MIX number was smaller than the experimental results. The experimental and calculated values of root mean square error (RMSE) increased with the increasing inlet flow velocity and the lowering of the positions of the PCMs.

Energy and exergy model with parametric study of a hot water storage tank with PCM for domestic applications and experimental validation for multiple operational scenarios

STUDY ON CHARGING AND DISCHARGING RATES OF LATENT HEAT THERMAL ENERGY STORAGE SYSTEMS EMPLOYING MULTIPLE PHASE CHANGE MATERIALS

A New Model of Phase Change Process for Thermal Energy Storage

Parametric Study on Melting Process of a Shell-and-tube Latent Thermal Energy Storage under Fluctuating Thermal Conditions

Investigation on the Melting Performance of a Phase Change Material Based on a Shell-and-Tube Thermal Energy Storage Unit with a Rectangular Fin Configuration

Experiments on Comparative Performance of Water Thermocline Storage Tank with and Without Encapsulated Paraffin Wax Packed Bed

Experimental and simulated optimization study on dynamic heat discharge performance of multi-units water tank with PCM

Heat pump water heater enhanced with phase change materials thermal energy storage: Modeling study

On the Behavior of Different PCMs in a Hot Water Storage Tank against Thermal Demands

Modeling of Thermal Energy Storage Shell-and-Tube Heat Exchanger

Experimental and Numerical Studies of Thermal Energy Storage using Paraffin Wax Phase Change Materials

Modeling of a PCM TES Tank Used as an Alternative Heat Sink for a Water Chiller. Analysis of Performance and Energy Savings

A simplified method for exergy assessment of thermal energy storage tanks: Comparative performance of tanks containing a phase-change material and water

Novel scheme for a PCM-based cold energy storage system. Design, modelling, and simulation

Thermal Energy Storage System Using a Technical Grade Paraffin Wax as Latent Heat Energy Storage Material

CFD Analysis of a Latent Thermal Storage System (PCM) for Integration with an Air-Water Heat Pump

Investigation of the Dynamic Melting Process in a Thermal Energy Storage Unit Using a Helical Coil Heat Exchanger

Experimental and numerical analysis of a phase change material-based shell-and-tube heat exchanger for cold thermal energy storage

Development and experimental investigation of full-scale phase change material thermal energy storage prototype for domestic hot water applications

The Thermal Stratification Evaluation of Phase-Change Materials in a Heat Storage Tank: Computational Fluid Dynamics and Experimental Study

Subcooling Effect on PCM Solidification: A Thermostat-like Approach to Thermal Energy Storage