Abstract:This paper presents a current starved sleep voltage-controlled oscillator(VCO) for the Phase Locked Loop (PLL) at high frequency with low power. The PLL's significance is still vital in many communication systems today, such as GPS system, clock data recovery, satellite communication, and frequency synthesizer. The PLL design for low voltage applications has many challenges, such as leakage power, supply voltage fluctuations. The VCO is an electronic oscillator which produces oscillating frequency for the control voltage. Current starved VCO is popular among the oscillators because it offers the right balance between low area, wide tuning range. VCO's power consumption is most significant and has an impact on the performance of the low power PLL. This work proposes the many inverter delay techniques (stack delay cell, sleepy stack delay cell, sleep delay cell) techniques in current starved VCO, resulting in reduced leakage power consumption. Introducing the sleep transistor between the pull-up MOSFET and supply voltage in an inverter induces a reverse bias, causing the reduction in sub-threshold leakage current when both are in off condition. The current starved sleep VCO has been designed using CMOS 90nm technology and investigated at the operating frequency of 1 GHz and wide tuning range from 0.5GHz-5.8GHz. It is to be observed that the power dissipation of the VCO is 8.12μ W, which is 2.3X lesser to the conventional VCO, the phase noise of -115dBc/Hz @1MHz and figure of merit value of -228.2dBc/Hz.
What problem does this paper attempt to address?
The problem that this paper attempts to solve is to design a low - power and high - frequency current - limited sleep voltage - controlled oscillator (VCO) in phase - locked loop (PLL) applications. Specifically, the paper focuses on the fact that in modern communication systems, such as GPS systems, clock data recovery, satellite communication and frequency synthesizers, the importance of PLL is still significant. However, PLL design for low - voltage applications faces many challenges, such as leakage power and supply voltage fluctuation problems. As a key component in PLL, the performance of VCO directly affects the performance of the entire system, especially the power consumption and frequency tuning range. Therefore, the paper proposes several delay cell techniques (stacked delay cell, sleep - stacked delay cell, sleep delay cell) aiming to reduce leakage power consumption while maintaining a wide frequency tuning range.
Through these improvements, the paper aims to achieve the following goals:
1. **Reduce power consumption**: By introducing sleep transistors, the sub - threshold leakage current is reduced, thereby reducing the overall power consumption.
2. **Increase the frequency tuning range**: By optimizing the design of the delay cell, a wider frequency tuning range is achieved.
3. **Maintain high performance**: While reducing power consumption, maintain or improve the phase noise performance and other key indicators of VCO.
The specific contributions of the paper include:
- Designing a current - limited sleep VCO based on 90 - nm CMOS technology and validating it at an operating frequency of 1 GHz.
- Achieving a wide frequency tuning range from 0.5 GHz to 5.8 GHz.
- Reducing the power consumption to 8.12 μW, which is 2.3 times lower than that of the traditional VCO.
- Achieving a phase noise performance of - 115 dBc/Hz and a figure - of - merit of - 228.2 dBc/Hz.
In conclusion, through the innovative design of the delay cell, this paper successfully resolves the contradiction between low power consumption and high - frequency tuning range, providing a new solution for the application of PLL in modern communication systems.