Abstract:In recent years, offshore wind energy has become an attractive option due to the increased demand for the renewable energy. A method incorporating a tuned mass damper (TMD) in offshore wind turbine platform is proposed to demonstrate the improvement on structural dynamic performance in this investigation. The Lagrange's equations are applied to establish a limited degree-of-freedom (DOF) mathematical model for the barge-type offshore wind turbine. Genetic algorithm (GA) is then employed to find the globally optimum TMD design parameters. Numerical simulations based on FAST have been carried out to evaluate the effect of the passive control system. A changeable mass for the floating wind turbine will be brought for installing a heavy tuned mass damper in the platform. In this case, partial ballast is substituted for the equal mass of the tuned mass damper, and the vibration mitigation is simulated in five typical load cases. Results show that the passive control approaches can improve the dynamic responses of the barge-type wind turbine by placing a tuned mass damper in floating platform. Through replacing partial ballast with the equal mass of the tuned mass damper, a significant reduction of dynamic responses is also observed in simulation results for the barge-type floating structure. Introduction Wind energy is very important in development and utilization of the sustainable new energy. In Denmark, as much as 20% of the electric power is provided from wind energy annually, and the percentage is towards reaching 50% in the coming decades [1]. Tens and even hundreds of offshore wind turbines can form a large wind farm in the huge available deep water area, and this also makes it possible to improve the power generation efficiency [2]. Therefore, the development of the offshore floating wind turbines is now appearing as an upcoming approach to deal with these propositions. The offshore floating wind turbines are subjected to extreme wind and wave-induced loads in harsh marine environment, utilizing a control strategy to mitigate the dynamic vibrations for the floating turbines is necessary. Jonkman et al. [3] investigated the use of the aero-hydro-servo-elastic code FAST developed by National Renewable Energy Laboratory (NREL) to simulate the structural responses for barge-type offshore floating wind turbines in different working conditions. Through integrating a passive control code into FAST, Lackner et al. [4] proposed an approach using a TMD configuration in the nacelle of the barge-type offshore floating turbines to achieve the structural vibration mitigation, and the control effectiveness of TMD for Spar and TLP-type were also studied. He et al. [5, 6] proposed the use of TMDs in nacelle to reduce the structure vibration for the barge-type floating turbines, and the results showed that the tower fore-aft displacements suppression rate was 38.7%. The complexity of floating wind turbines has not yet been fully understood, and this complexity is crucial towards developing cost-effective floating wind turbines to harness wind energy in deep water sites. Therefore, many scaling model experiments were undertaken to investigate the vibration responses of a model offshore floating wind turbine in realistic wind and wave conditions [7-9]. These researches could benefit the offshore wind industry by improving the design of the concept. Almost all of studies mentioned above are focusing on the installation of the TMD in the tower top

Structural control for a barge-type floating offshore wind turbine with a skyhook inerter configuration

Load mitigation for a barge-type floating offshore wind turbine via inerter-based passive structural control

Inerter-based Passive Structural Control for Barge Floating Offshore Wind Turbines

Structural Control for an Offshore Wind Turbine with a Tuned Mass Damper in Floating Platform

Active structural control of a floating wind turbine with a stroke-limited hybrid mass damper

Load Mitigation for a Floating Wind Turbine Via Generalized Structural Control

Passive structural control of offshore wind turbines

Modelling and Optimization of a Passive Structural Control Design for a Spar-Type Floating Wind Turbine

Passive Vibration Control of a Semi-Submersible Floating Offshore Wind Turbine

Structural vibration control for the offshore floating wind turbine including drivetrain dynamics analysis

Structural Control of an Ultra-Large Semi-Submersible Floating Offshore Wind Turbine

TMD stroke limiting influence on barge-type floating wind turbines

Adaptive Structural Control of Floating Wind Turbine with Application of MR Damper

Modeling and optimization of multiple tuned mass dampers for a barge-type floating offshore wind turbine

Offshore Wind Turbine Load Reduction Employing Optimal Passive Tuned Mass Damping Systems

Active structural control of floating wind turbine with Multi-TMD based on LQR optimal control

Structural Control of the Ultra-Large Semi-Submersible Floating Offshore Wind Turbine

Study on TMD Control on Stability Improvement of Barge-Supported Floating Offshore Wind Turbine Based on the Multi-Island Genetic Algorithm

Vibration control of spar‐type floating offshore wind turbine towers using a tuned mass‐damper‐inerter

Integrated Numerical Investigation of a 15 MW Semi-Submersible Wind Turbine at Moderate Water Depth

Coupled modeling and structural vibration control for floating offshore wind turbine