Polymer Flooding - Towards a Better Control of Polymer Mechanical Degradation at the Near Wellbore

Sandeep Garrepally,Stephane Jouenne,Franpois Leuqeux,Peter D. Olmsted

DOI: https://doi.org/10.2118/200373-ms

2020-08-30

Abstract:Abstract Polymer flooding with visco-elastic polymers is an EOR technique improving both macro and microscopic recovery of oil. Its efficiency can be greatly limited by mechanical and chemical degradation of polymers. When injected in the reservoir, the early few centimeters travelled through the rock are crucial for determining the degradation undergone (degradation being defined as the irreversible loss of viscosity). Our aim is is to establish predictive laws for the degradation of polymer solutions flowing through porous media and for the associated flow thickening which can mobility reduction curves of polymer solutions injected or re-injected through sintered ceramic cores of length varying between 1 and 8 mm, we develop a model for predicting mobility reduction and degradation at any length of porous medium, any flux. The model is built by considering that a single injection at flux J on a core having a length NL0 is equivalent to N successive injections at flux J on a piece of the core of length L0. In linear fow, it is found that degradation increases sharply for the first few millimeters and then tends toward a quasi steady state value after a critical length Lc which decreases for increasing fluxes. This model is then transposed to radial flow. Similarly, there exists a critical distance Dc at which degradation reaches a steady state value. Dc is an increasing function of the injection well radius Rw and tends towards Lc at high Rw since radial flow becomes nearly linear. Results obtained with the model are then discussed for predicting precisely on which distance degradation will be experienced and for determining if degradation experiments performed in linear flow in the lab are representative of radial flow around a real polymer injector. This study is a first in injecting polymer solutions through cores as short as 1 mm and in predicting mobility reduction and degradation in both linear and radial flow profiles.