Abstract:Flywheels generate speed-related disturbances and induce micro-vibrations that influence the performance of high-sensitivity instruments on board. This study addresses dynamic modeling and disturbance force suppression of the flywheels due to its inherent characteristic structural modes. The disturbance force transmission of a rotating flywheel due to a unit radial force applied at the rim of the wheel body is reported using the three-dimensional finite element method and frequency response function–based substructuring method. The characteristic structural modes for the radial and axial disturbance forces are identified. The axial deformation–dominated flapping mode and the radial deformation–dominated transverse mode will contribute most to the axial and radial disturbance forces, respectively. A flexible ring structure, which is rested on the arms of the wheel body through independent viscoelastic pads and simultaneously in contact with the inner rim of the wheel body by independent resilient cushion members, is proposed to function as a damped dynamic vibration absorber. The modes of the dynamic vibration absorber and the modes of the flywheel equipped with the dynamic vibration absorber are analyzed. It is shown that the dynamic vibration absorber is effective to suppress both the radial and axial disturbance forces at the characteristic structural modes under different rotational speeds, provided that the loss factor of the complex elastic modulus for the viscoelastic pads is larger than 0.2 and the proportional damping constant for the stiffness matrix is larger than 6 Ns/m. Experimental analyses are conducted on a flywheel with a well-designed dynamic vibration absorber to validate the theoretical findings. Modal tests and disturbance force measurements are carried out for the flywheel with/without the dynamic vibration absorber. It is shown that the identified characteristic structural modes will contribute remarkable peaks for the radial and axial disturbance forces. The proposed dynamic vibration absorber is capable to suppress the high-frequency disturbance forces efficiently under different rotational speeds.

Developments in the Design of Centrifugal Pendulum Vibration Absorbers

Analysis on Dynamic Characteristics and Design of Centrifuge

Dynamic stability and efficiency of centrifugal double pendulum vibration absorbers

Response of centrifugal pendulum vibration absorber considering gravity at low engine speed

Centrifugal pendulum vibration absorber with geometric nonlinear damping

The localised response and filtering performance of centrifugal pendulum vibration absorbers allowing a rotational mobility

Design and validation of a nonlinear vibration absorber to attenuate torsional oscillations of propulsion systems

Vibration Control of a Flywheel by a Friction Ring Dynamic Vibration Absorber

Multi-body-Simulation of a Self Adaptive Torsional Vibration Absorber

An elastic rotative nonlinear vibration absorber (ERNVA) as a passive suppressor for vortex-induced vibrations

Optimal Design of Tuned Mass Dampers With Variable Inerter and Damping

Design and Closed Loop Testing of High-Pressure Centrifugal Gas Compressors for the Suppression of Subsynchronous Vibration

High-frequency Disturbance Force Suppression Mechanism of a Flywheel Equipped with a Flexible Dynamic Vibration Absorber

Vibration control of a flexible inverted pendulum using the planned flywheel motion

A design methodology for passive mechatronic vibration absorbers

Vibration and Aerodynamic Analysis and Optimization Design of a Test Centrifuge

Design of a flexible dva in vibration transmission control of a flywheel at its flapping mode

H∞ Optimization of a Novel Maxwell Dynamic Vibration Absorber with Lever, Inerter, and Grounded Stiffness

Nonlinear dynamics of torsichrone CPVA with synchroringed form closure constraint

Edgewise vibration control of wind turbine blades using roller and liquid dampers

MPC-based Vibration Control and Energy Harvesting Using an Electromagnetic Vibration Absorber With Inertia Nonlinearity