Abstract:This study investigates the decolorization of two widely used textile dyes (Acid Black 172 (AB172) and Disperse Blue 56 (DB56) by using a combined sono-photo-electro-Fenton (SPEF) process. The effects of dye structure and processing factors on dye degradation from contaminated water and COD removal efficiency were determined by adopting response surface methodology. The results confirmed that current density, irradiation time, pH, ({ aise0.7exhbox{({{ ext{H}}_{{2}} { ext{O}}_{{2}} })} !mathord{left/ {vphantom {{{ ext{H}}_{{2}} { ext{O}}_{{2}} } {{ ext{C}}_{{0}} }}} ight.kern-0em} !lower0.7exhbox{({{ ext{C}}_{{0}} })}}), and AB172 concentration had the most impacts on COD removal, respectively, whereas DB56 removal efficiency was highly dependent on the initial dye concentration and ({ aise0.7exhbox{({{ ext{H}}_{{2}} { ext{O}}_{{2}} })} !mathord{left/ {vphantom {{{ ext{H}}_{{2}} { ext{O}}_{{2}} } {{ ext{C}}_{{0}} }}} ight.kern-0em} !lower0.7exhbox{({{ ext{C}}_{{0}} })}}), compared to other processing factors. The dye degradation efficiency of 95.5% and COD removal efficiency of 91.6% for DB56 were obtained at optimum conditions of pH = 3, current density = 2 mA.cm−2, dye concentration = 200 ppm, ({ aise0.7exhbox{({{ ext{H}}_{{2}} { ext{O}}_{{2}} })} !mathord{left/ {vphantom {{{ ext{H}}_{{2}} { ext{O}}_{{2}} } {{ ext{C}}_{{0}} }}} ight.kern-0em} !lower0.7exhbox{({{ ext{C}}_{{0}} })}}) of 0.78 and irradiation time of 30 min. In the case of AB172, the same optimum conditions were found unlike reaction time of 50 min and ({ aise0.7exhbox{({{ ext{H}}_{{2}} { ext{O}}_{{2}} })} !mathord{left/ {vphantom {{{ ext{H}}_{{2}} { ext{O}}_{{2}} } {{ ext{C}}_{{0}} }}} ight.kern-0em} !lower0.7exhbox{({{ ext{C}}_{{0}} })}}) of 0.33, which resulted in the optimal dye degradation efficiency and COD removal of 97.4% 94.5%, respectively. These results verified that the type of dye and its structure can be a key factor in the Fenton-based degradation process. The comparison of the performance of different Fenton-based processes confirmed that the removal efficiency of electro-Fenton, sono-electro-Fenton, photo-electro-Fenton, and SPEF was 82–88%, 89.5–91%, 91.5–92.3% and 95.5–97.4%, respectively. The Fenton-based processes are highly effective methods that can be applied for water and wastewater treatment.Graphic

Acid Blue 25 Removal by using Electro-Persulfate Process

Optimization of the Acid blue 113 dye degradation in the three-dimensional electro persulfate process (3D/EPS) catalyzed by granular activated carbon (GAC) using the response surface methodology

Application of electrospun Polyamide-6/Modified zeolite nanofibrous composite to remove Acid Blue 74 dye from textile dyeing wastewater

Electro-Fenton Process for the Removal of Direct Red 23 Using BDD Anode in Chloride and Sulfate Media

Degradation of Acid Orange 7 in aqueous solution by a novel electro/Fe2+/peroxydisulfate process

Investigation and optimization of the performance of sono-photo-electro-Fenton process for removal of Acid Black 172 and Disperse Blue 56 from polluted water: comparison of the degradation activity with electro-Fenton-based processes

Electro-peroxone treatment of Orange II dye wastewater.

Ultraviolet radiation/persulfate/hydrogen peroxide treatment system for the degradation of acid blue 80 dye from a batch flow chemical reactor: effects of operational parameters, mineralization, energy consumption, and kinetic studies

Electrocoagulation treatment for Remazol Brilliant Blue R (Reactive Blue 19) removal of textile dye simulated wastewater using iron-aluminum electrodes

Removal of acid red dye 1 from textile wastewater by heterogenous photocatalytic ozonation employing titanium dioxide and iron zeolite

Removal of polyvinylamine sulfonate anthrapyridone dye by application of heterogeneous electro-Fenton process

Improvement of electro-Fenton process by using heterogeneous Fe-MIL-88B nanocatalyst and simultaneous rotation of cathode and anode for dye removal

Degradation of Remazol Brilliant Blue Dye Using Persulfate Activated by Fe3O4@PDA Nanoparticles: Kinetic Studies, Radical Determination, and Phytotoxicity Test

RESPONSE SURFACE METHODOLOGY APPLIED TO ELECTRO-FENTON PROCESS FOR DEGRADATION OF RED BEMACID AS TEXTILE DYE MODEL

Electro-Fenton degradation of synthetic dyes

Removal of Staphylococcus aureus using electro-fenton, UV/H2O2, and combination of electro-fenton and UV/H2O2 processes; optimization of operational parameters

Electro-Fenton method for the removal of methyl red in an efficient electrochemical system

The effect of silica-doped graphene oxide (GO-SiO2) on persulfate activation for the removal of Acid Blue 25

Exploring the intensifying effect of periodate/hydroxylamine oxidation process for the effective mineralization of textile dyes effluents with consideration of environmental matrices

Enhancing textile wastewater decolorization: harnessing the power of diverse oxidants in photo-oxidation process with response surface methodology

Enhanced degradation of Rhodamine B dye by Fenton/peracetic acid and photo-Fenton/peracetic acid processes