Abstract:The thermal conversion of waste plastic products can provide a promising solution to the issues of environmental pollution, waste management, and energy needs. However, our present understanding on the thermal reforming of different kinds of plastic wastes mixtures during their co-pyrolysis and co-gasification for syngas production and energy recovery is insufficient. Non-selective urban polypropylene (PP) and polystyrene (PS) waste plastics were chosen for the investigations reported here. Thermal degradation properties of PP and PS as well as their blends in different mass ratios were investigated via thermogravimetric (TG) analysis. Co-pyrolysis and CO 2 -assisted co-gasification of PP-PS blends were then conducted using a fixed-bed reactor at a temperature of 1173 K. Experimental results from the blends were then compared with the weighted value calculated from their component feedstocks to quantify the degree of synergistic effect. TG results showed that the co-treatment of PP and PS enhanced the respective devolatilization process. The co-pyrolysis of PP and PS enhanced their thermal cracking, leading to synergistic increases in the yields of H 2 , light hydrocarbons (HC) and total syngas. In co-gasification, the reforming reaction involving CO 2 was synergistically enhanced, resulting in the increased yields of H 2 and HC. The gasification reactivity of carbon black improved during the co-processing of PP and PS due to the synergistic effect between the two different kinds of plastics. Higher synergistic effects were observed from the plastic mixtures having higher PS content that resulted in increased yield of syngas. Co-gasification of PP-PS blends having 40% PP content (2P3S) exhibited the maximum synergistic effect on H 2 , CO, and total syngas showing increased yields by 88.8%, 77.7%, and 74.2% respectively. The lowest synergistic effect was observed for HC that showed increased yield of only 25.1%. The optimal CO 2 consumption was also observed from the co-gasification of 2P3S. Each gram of 2P3S feedstock consumed approximately 1.80 g of CO 2 to result in highest recovered energy of 27.49 kJ/g and the maximum overall energy efficiency of 43.2%. The results revealed that enhanced thermal cracking and CO 2 reforming reaction, along with the improved reactivity of carbon black were mainly responsible for increased yields of H 2 , HC, CO and total syngas during co-gasification. This study contributes to the fundamental understanding of co-processing of non-separated waste plastics for enhanced syngas production and energy recovery, elucidating the synergistic effect between the various kinds of plastics during their co-pyrolysis and co-gasification.

On deconvolution for understanding synergistic effects in co-pyrolysis of pinewood and polypropylene

Towards enhanced understanding of synergistic effects in co-pyrolysis of pinewood and polycarbonate

Influence of Char Intermediates on Synergistic Effects During Co-Pyrolysis of Pinewood and Polycarbonate

Quantifying the Sources of Synergistic Effects in Co-Pyrolysis of Pinewood and Polystyrene

Insight into synergistic effects of biomass-polypropylene co-pyrolysis using representative biomass constituents

Synergistic Effects on Char and Oil Produced by the Co-Pyrolysis of Pine Wood, Polyethylene and Polyvinyl Chloride

Synergetic Effect of Co-pyrolysis of Cellulose and Polypropylene over an All-Silica Mesoporous Catalyst MCM-41 Using Thermogravimetry–Fourier Transform Infrared Spectroscopy and Pyrolysis–Gas Chromatography–Mass Spectrometry

Synergistic effects during co-pyrolysis and co-gasification of polypropylene and polystyrene

Co-pyrolysis of pinewood and HDPE: pyrolysis characteristics and kinetic behaviors study

Investigation on the Synergistic Effect Between Different Components in Pyrolysis of Paper-Plastic Composite Material

Co-pyrolysis of Platanus Wood and Bituminous Coal: Product Distributions, Char Pore Analysis and Synergistic Effects

Synergetic Effects During Co-Pyrolysis of Woody Biomass and Zhundong Coal

Synergistic effects during co-pyrolysis of biomass and plastic: gas, tar, soot, char products and thermogravimetric study

Investigation of kinetics, reaction mechanisms, thermodynamics, and synergetic effects in co-pyrolysis of wood sawdust and linear low-density polyethylene using the thermogravimetric approach

Review on synergistic effects during co-pyrolysis of biomass and plastic waste: Significance of operating conditions and interaction mechanism

Co-pyrolysis of oil-based drill cuttings and pinewood sawdust: Thermal behavior, synergistic effect, artificial neural network and empirical reaction model

Synergetic effects during co-pyrolysis of biomass and waste tire: A study on product distribution and reaction kinetics.

Investigation on Synergistic Effects and Char Morphology During Co-pyrolysis of Poly(vinyl Chloride) Blended with Different Rank Coals from Northern China

Synergistic Effects and Kinetic Analysis in Co-Pyrolysis of Peanut Shells and Polypropylene

Synergistic interactions between sewage sludge, polypropylene, and high-density polyethylene during co-pyrolysis: An investigation based on iso-conversional model-free methods and master plot analysis

Synergistic effect of Hami coal and polystyrene on products properties during co-pyrolysis: Evaluation on the contribution of different interaction sources