Abstract:External gear pumps are among the most popular fluid power positive displacement pumps; however, they often suffer from excessive flow pulsation transmitted to the downstream circuit. To meet the increasing demand of quiet operation for modern fluid power systems, it is necessary to give a physically sound method of analyzing the operation of a volumetric pump. The analysis of the basic approach used by the majority of researchers for calculating the flow rate of a gear pump by E.M. Yudin is presented. The article presents a new method for analyzing the operation of volumetric pumps. The method is suitable for the pumps whose dynamic characteristics should be considered according to the model of an equivalent source of flow fluctuations by V.P. Shorin. The method is based on wave theory, the method of hydrodynamic analogies and the impedance method, where the pump is considered according to the model in lumped parameters. The method consists in determining the pressure pulsations at the pump output in bench systems with known dynamic characteristics and recalculating the pump flow rate in pulsations. Computational dynamic models of bench systems in lumped parameters are proposed for subsequent use in dynamic tests of pumps in the form of equivalent sources of fluid flow fluctuations. We give recommendations for the formation of test bench systems with a throttle, a cavity and a pipeline at the pump output. Using the example of an external gear pump with a working volume of 14 cm3/rev, the implementation of the proposed method is considered. The pump's own pulsation characteristic of the flow rate in a bench system with an "infinitely long" pipeline along two harmonic components of the spectrum is determined, and a test of the method based on the method of determining the instantaneous flow rate by R.N. Starobinskiy is proposed. It is shown that, according to the proposed method and the method of R.N. Starobinskiy, the divergence of the amplitudes of flow pulsations does not exceed (5–10)%. The high degree of coincidence of the results confirms that the external gear pump in question should be considered according to the equivalent source of flow fluctuations model.

EXPERIMENTAL ESTIMATION OF ACOUSTIC EFFICIENCY OF APPLICATION OF POLYMERIC MATERIALS IN THE PUMP DESIGN

Experimental Investigation on the Noise Reduction of an Axial Piston Pump Using Free-Layer Damping Material Treatment

New Method to Determine the Dynamic Fluid Flow Rate at the Gear Pump Outlet

Study On Acoustic Performance Of A Water Muffler For Gear Pump

A Hybrid Lumped Parameters/Finite Element/Boundary Element Model to Predict the Vibroacoustic Characteristics of an Axial Piston Pump

Noise Evaluation of S-Polymer Gears

Numerical and Experimental Studies on Housing Optimization for Noise Reduction of an Axial Piston Pump

Experimental studies of the vibro-acoustic characteristics of an axial piston pump under run-up and steady-state operating conditions

Designing a Polymer Gear for Use in the Environment of an Internal Combustion Engine

Analysis of design and technological features of gear pumps

Experimental Investigation on the Sharpness Reduction of an Axial Piston Pump with Reinforced Shell

Polymer materials used to reduce waterjet wear of pump parts

Optimal Design of Rotor Profile of Internal Gear Pump for Noise Reduction

Comparison of the noise produced by the polymer and bronze P1566 propellers in the cavitation tunnel

Evaluation of the Operational Reliability of Gear Hydraulic Pumps Repaired Using the Electric Spark Processing Method

Towards Highly Efficient, Additively Manufactured Passive Vibration Eliminators for Mechanical Systems

IMPROVEMENT OF ACOUSTIC PARAMETERS OF HYDRAULIC DRIVES

Investigation Into The Effects Of Index Angle On Fluidborne Noise And Structureborne Noise Of A Tandem Axial Piston Pump

Noise Evaluation of Coated Polymer Gears

Analysis of impact of rotation speed changes on pressure pulsation of positive displacement pump