Abstract:While renewable energy fuel has always had no cost, in the past the cost of the energy conversion technology was prohibitive. Today, due to improved efficiency in the technology and substantial increases in manufacturing volume the cost to generate electricity from the renewables and the cost to store this electricity in lithium-ion batteries for four hours has made these technologies more than competitive with traditional sources. As higher renewable energy penetrations occur the variability and intermittent nature of solar photovoltaic (PV) electricity can cause steep ramping of conventional power plants, so longer term energy storage (days, weeks, instead of hours) will be needed to increase the reliability of grid operation. In Florida cloud cover of a PV field can cause rapid fluctuations of PV output requiring a fast response to smooth out the PV electric power output. A polymer electrolyte membrane (PEM) electrolyzer can serve as a utility controllable load that can be available at all times and the produced hydrogen can be sold or converted back into electricity directly through a PEM fuel cell. To study the integration of renewable solar with hydrogen for increasing grid reliability, a multi-software power control method and a transient thermal electrochemical PEM electrolyzer model has been developed. One-dimensional ("through-plane") and two-dimensional ("through-plane" and "in-plane") un-steady state models using gPROMS 2.1.1. were developed. The model considers mass, energy, momentum and current balance equations. The thermal energy balance considers the heat transfer through the backing layer, the flowfield plates and the gas and liquid flows. Kinetic parameters used in the model were determined using parameter estimation of single cell steady state polarization curves [1]. The single cell unsteady state models were extended to a stack model by adding cells in series and parallel. Real-time PV data taken from a 8.9 MW AC solar farm from Orlando Utilities Commission's Stanton Energy Center was scaled up to 75 MW AC to design the electrolyzer that would be sized with the typical utility PV installation in Florida. The 75 MW PV data was smoothed using a power control strategy developed in MATLAB. The developed multi-software power control method and the electrochemical dynamic stack model shows the effectiveness of an electrolyzer in smoothing the PV signal to increase the grid stability and flexibility. Results are presented of different size electrolyzers to minimize short term cloud cover spikes in power while maximizing hydrogen production and the effectiveness of the electrolyzer. [1] Vincenzo Liso, Giorgio Savoia, Samuel Simon Araya, Giovanni Cinti and Søren Knudsen Kær, "Modelling and Experimental Analysis of a Polymer Electrolyte Membrane Water Electrolysis Cell at Different Operating Temperatures", Energies, 11 (2018) 3272. doi:10.3390/en11123273

Cell voltage static-dynamic modeling of a PEM electrolyzer based on adaptive parameters: Development and experimental validation

Experimental Validation of an Equivalent Dynamic Electrical Model for a Proton Exchange Membrane Electrolyzer

Electrochemical Performance Modeling of A Proton Exchange Membrane Electrolyzer Cell for Hydrogen Energy

Dynamic Emulation of a PEM Electrolyzer by Time Constant Based Exponential Model

Dynamic Electrical Equivalent Circuit Modeling of the Grid-Scale Proton Exchange Membrane Electrolyzer for Ancillary Services

Self-Discharge of a Proton Exchange Membrane Electrolyzer: Investigation for Modeling Purposes

Dynamic Electrical Circuit Modeling of a Proton Exchange Membrane Electrolyzer for Frequency Stability, Resiliency, and Sensitivity Analysis in a Power Grid

Modeling of Two-Phase Transport in Proton Exchange Membrane Electrolyzer Cells for Hydrogen Energy

Using the nonlinearity of a PEM water electrolyzer cell for its dynamic model characterization

Steady-State Voltage Modelling of a HT-PEMFC under Various Operating Conditions

An Electrochemical-Based Fuel-Cell Model Suitable for Electrical Engineering Automation Approach

Modeling the Dynamic Electrical Behavior of High Temperature Electrolysis for Hydrogen Production

Mathematical Modeling and Experimental Validation for a 50 Kw Alkaline Water Electrolyzer

Electrical circuit modeling of proton exchange membrane electrolyzer: The state-of-the-art, current challenges, and recommendations

Performance assessment and economic perspectives of integrated PEM fuel cell and PEM electrolyzer for electric power generation

Pressurized PEM water electrolysis: Dynamic modelling focusing on the cathode side

Thermodynamical and electrochemical model of a PEM electrolyzer plant in the megawatt range with a literature analysis of the fitting parameters

Proton Exchange Membrane Electrolyzer Systems Operating Dynamically at High Current Densities

Transient Modeling and Optimization of a PEM Electrolyzer for Solar Photovoltaic Power Smoothing

Sensitivity analysis and uncertainty quantification in predictive modeling of proton-exchange membrane electrolytic cells

Design and Implementation of the Luenberger Observer for Estimating the Voltage Response of a PEM Electrolyzer During Supply Current Variations