Fast 3D printing of large-scale biocompatible hydrogel models

Nanditha Anandakrishnan,Hang Ye,Zipeng Guo,Zhaowei Chen,Kyle I. Mentkowski,Jennifer K. Lang,Nika Rajabian,Stelios T. Andreadis,Zhen Ma,Joseph A. Spernyak,Jonathan F. Lovell,Depeng Wang,Jun Xia,Chi Zhou,Ruogang Zhao
DOI: https://doi.org/10.1101/2020.10.22.345660
2020-10-22
Abstract:Abstract Large scale cell-laden hydrogel models hold great promise for tissue repair and organ transplantation, but their fabrication is faced with challenges in achieving clinically-relevant size and hierarchical structures. 3D bioprinting is an emerging technology, but its application in large, solid hydrogel fabrication has been limited by the slow printing speed that can affect the part quality and the biological activity of the encapsulated cells. Here we present a Fast hydrogeL prOjection stereolithogrAphy Technology (FLOAT) that allows the creation of a centimeter-sized, multiscale solid hydrogel model within minutes. Through precisely controlling the photopolymerization condition, we established low suction force-driven, high-velocity flow of the hydrogel prepolymer that supports the continuous replenishment of the prepolymer solution below the curing part and the nonstop part growth. We showed that this process is unique to the hydrogel prepolymer without externally supplemented oxygen. The rapid printing of centimeter-sized hydrogel models using FLOAT was shown to significantly reduce the part deformation and cellular injury caused by the prolonged exposure to the environmental stresses in layer-by-layer based printing methods. Media perfusion in the printed vessel network was shown to promote cell survival and metabolic function in the deep core of the large-sized hydrogel model over long term. The FLOAT is compatible with multiple photocurable hydrogel materials and the printed scaffold supports the endothelialization of prefabricated vascular channels. Together, these studies demonstrate a rapid 3D hydrogel printing method and highlight the potential of this method in the fabrication of large-sized engineered tissue models.
What problem does this paper attempt to address?