Abstract:Abstract Pipe joints are weak points in non-metallic pipeline systems, and their mechanical strength is essential for ensuring safe pipeline operation. By reinforcing with short carbon fiber reinforced thermoplastic composites (SCFRTCs), the mechanical strength of pipe joints shows great improvement. Understanding the failure mechanisms of SCFRTCs joints is crucial for further structural enhancement and safe operation. In this study, the failure mode of SCFRTCs joints is first investigated through bursting tests. Microstructural analysis using Scanning Electron Microscopy (SEM) and Computed Tomography (CT) reveals that stress concentration at the SCFRTCs joint initiates cracks formation. The progressive propagation of these cracks, leading to ultimate failure, is identified as the primary failure mechanism. Subsequently, a finite element model of SCFRTCs joints, incorporating contour integration for crack propagation, is constructed, and the energy release rate for crack propagation of SCFRTCs are experimentally determined. Simulation results confirm the stress concentration-induced crack initiation. Furthermore, the effect of joint wall thickness on structural strength of the SCFRTCs joint is analyzed. Increasing wall thickness improves the mechanical strength of SCFRTCs joint. However, most of the SCFRTCs in the joint remain at low stress levels, far from yielding when the crack initiates. As wall thickness increases, the strength utilization rate of SCFRTCs gradually decreases from 49.0% to as low as 14.9%, indicating that increasing wall thickness is not an effective method for enhancing structural strength, particularly under conditions of large wall thickness.

Research on Digital Radiographic Inspection of In-Service Fiber Reinforced Plastic Pipe

Study on Industrial Computed Tomography Detection and Identification of Inclusion Defects in Thick-Wall Polyethylene Pipe Butt Fusion Joint Within Nuclear Power Plant

Research on Phased Array Ultrasonic Technique for Testing Butt Fusion Joint in Polyethylene Pipe

Investigation on Failure Mode of Short Carbon Fiber Reinforced Thermoplastic Composites Joints of Non-metallic Pipeline

Noncontact Laser Inspection Based on a PSD for the Inner Surface of Minidiameter Pipes.

Non-Contact Inspection for Inner Surface of Small-Diameter Pipes Based on Laser-Psd

Safety Test Research of Pressure Pipes Containing Incomplete Welding Defects

Research on Ultrasonic Testing for Electro-Fusion Joint of Reinforced Thermoplastic Pipes

The monitoring approaches and non-destructive testing technologies for sewer pipelines

Research On Safety Assessment Method For Pressure Pipe With Incomplete Welding Defects Under Complicated Loadings

A New Accurate Quantitative Inspection Technology to the Corrosion for the Offshore Erect Pipeline

Modelling and experimental study on pipeline defect characterisations using a pulsed eddy current measurement

NONDESTRUCTIVE TESTING TECHNIQUE FOR CRACKS IN LONG-DISTANCE NATURAL GAS PIPELINES

Application of Ultrasonic Guided Waves for Inspection of High Density Polyethylene Pipe Systems

A Method of Ultrasonic Phased Array Inspection of Middle-High Pressure Plastic Pipe Reinforced by Cross Helically Wound Steel Wires Electro-Fusion Joint

Analysis of load carrying performance for glass fiber reinforced thermoplastic composite pipe under different in-service conditions

Preliminary study on terahertz non-destructive testing for defect detection in hot melt joints of polyethylene pipes

Pipeline leak detection and corrosion monitoring based on a novel FBG pipe-fixture sensor

Investigation On Mechanical Properties Of Fiberglass Reinforced Flexible Pipes Under Bending

Phased Array Ultrasonic Testing on Thick Glass Fiber Reinforced Thermoplastic Composite Pipe Implementing the Classical Time-Corrected Gain Method

Simulation of defect detection for the buried petroleum pipe by the X-ray backscatter imaging