Abstract:Composite overwrapped pressure vessels (COPVs) are widely used in the field of high-pressure gas storage and transportation because of their light weight and high strength. In engineering, autofrettage is usually used to improve the fatigue life of composite pressure overwrapped vessels with metal liners. However, excessive pressure of autofrettage could cause buckling damage to the metal liner. In order to determine the upper limit of autofrettage (critical buckling pressure) and analyze its influence on the safety factor of COPVs, a theoretical calculation model of the critical buckling pressure about the metal liner was established based on classical laminated plate theory and the confined buckling theory. Then, a COPV with thin-walled welded metal liner was prepared by fiber winding process. In order to monitor and judge the buckling damage mode of the liner, the circumferential strain of the COPV's cylinder was measured by loading and unloading step-by-step. Finally, the influence of materials and dimensions of the metal liner on the pressure ratio (the ratio of the first layer failure pressure to the critical buckling pressure of the COPV's metal liner) was discussed. When the diameter to thickness ratio (R/t) of the metal liner was greater than 35, the pressure ratios of the 6063-T5 aluminum alloy liner and the S30408 stainless steel liner both exceeded 2.25. However, the pressure ratio of 6061-T6 aluminum alloy liner with R/t ≤ 60 was lower than 1.85, which shows that the metal liner with higher yield strength and lower elastic modulus has higher utilization rate of fiber winding layers. Due to the fact that the current design standards only ensure the reliability of COPVs through safety factors and various type testing with their evaluation methods, the proposed theoretical calculation method can reduce the uncertainty of COPVs during the design and testing rounds.

Structural Design and Stress Analysis of a Fully-Wrapped Composite CNG Gas Cylinder With Nominal Working Pressure of 30 MPa

Mechanical Analysis and Optimal Design for Carbon Fiber Resin Composite Wound Hydrogen Storage Vessel With Aluminum Alloy Liner

Mechanical Analysis of Carbon Fiber Wound High Pressure Hydrogen Storage Vessel and Prestress Control in Manufacturing Process

Mechanical Analysis of Carbon Fiber Filament Wound Hydrogen Storage Vessel with Aluminum Alloy Liner

Optimal Control of Cylinder Wall's Stresses of Composite Material High-pressure Hydrogen Storage Vessel

DESIGN AND OPTIMIZATION OF HIGH-PRESSURE HYDROGEN CYLINDERS FOR INTERMODAL CONTAINER TRANSPORTATION

Study on Burst Pressure of Type Ⅳ Hydrogen Storage Cylinder Based on Progressive Failure Analysis

Mechanical Analysis and Reasonable Design for Ti-Al Alloy Liner Wound with Carbon Fiber Resin Composite High Pressure Vessel

Strength Analysis and Influence Factors Research of Carbon-Fiber Wound Composite Gas Cylinder With Aluminum Liner

Experimental Analysis on Residual Performance of Used 70 MPa Type IV Composite Pressure Vessels

Experimental and Numerical Study of the Static Performance of a Hoop-Wrapped CNG Composite Cylinder Considering Its Variable Wall Thickness and Polymer Liner

Strength and Failure Analysis of Fiber-Wound Composite Gas Cylinder via Numerical Simulation

Heat and Mechanical Response Analysis of Composite Compressed Natural Gas Cylinders at Vehicle Fire Scenario

Experimental Investigation on Burst Pressure and Fatigue Life of Type IV LPG Cylinders

Theoretical and Experimental Research on The Critical Buckling Pressure of The Thin-Walled Metal Liner Installed in The Composite Overwrapped Pressure Vessel

Design Fatigue Life Evaluation of High-Pressure Hydrogen Storage Vessels Based on Fracture Mechanics

Finite element analysis of strength of mobile cryogenic LNG storage tank

Thermo-mechanical Investigation of Composite High-Pressure Hydrogen Storage Cylinder During Fast Filling

Crack Growth Analysis Of High-Pressure Equipment For Hydrogen Storage

Instability Analysis and Development of High Pressure Hydrogen Storage Vessels

Method for producing carbon fiber-completely winded composite gas cylinder with aluminum inner container