Abstract:In this paper we present a numerical simulation of a porous journal bearing considering the fluid film – poroelastic matrix interaction and the non-Newtonian rheological behavior of nanolubricant consisting of base fluid and nanoparticles (NPs). The flow of nanolubricant in the bearing clearance space is described by the Vijay Kumar Stokes micro-continuum theory which considers the characteristic size of nanoparticles such as fullerenes dispersed in a base oil. The flow of the nanolubricant in the porous medium is modeled by the modified Darcy’s law where the Beavers–Joseph slip conditions are applied at the fluid film-porous matrix interface. The deformation of the fluid-film porous matrix interface due to hydrodynamic pressure is calculated by using a simplified analytical thin elastic liner model. The hydrodynamic behavior of lubricating film is governed by the modified Reynolds equation obtained from the momentum, moment of momentum, and mass conservation laws using the classical Reynolds derivation process. The bearing porosity is introduced into the governing modified Reynolds equation by means of the Morgan-Cameron approximation. The steady-state analysis shows that for an imposed operating eccentricity, the load capacity increases with the characteristic size and the concentration of NPs while the attitude angle, the leakage flow rate, and the coefficient of friction decrease. On the other hand, the permeability decreases the hydrodynamic pressure, the load capacity, and the leakage flow rate, and increases the attitude angle and the coefficient of friction.

Behavior of Conical Porous Hybrid Journal Bearing with Pseudoplastic Lubricant

Lubrication Performance Analysis of Lead-Bismuth Internal-Feedback Bearings in the Nuclear Main Pump System

Influence of Percolation effect of additives on the Performance of Conical Textured Porous Hybrid Journal Bearing

Design on Hybrid Ceramic Bearing Based on Water Based Fluid with Controllable Viscosity

Numerical and experimental investigation on the performance of hybrid porous gas journal bearings

A Study of Misaligned Compliant Journal Bearings Lubricated by Non-Newtonian Fluid Considering Surface Roughness

Piezo-viscous-polar lubrication of hybrid conical journal bearing with slip boundary conditions

Comparison of conical hybrid journal bearing performances for varying speeds

Numerical Modeling and Simulation of a Poroelastic Journal Bearing Lubricated By Nanofluids with Couple-Stresses

A Comparative Analysis of the Performance of Micropolar Fluid Lubricated Single-Layered and Double-Layered Porous Journal Bearing.

Piezo-viscous-polar lubrication of hybrid journal bearing under misaligned operation

Steady state analysis of a porous bearing lubricated by nanofluids

Numerical Analysis of Journal Bearings Lubricated with Micropolar Fluids Including Thermal and Cavitating Effects

Evaluation of the performance characteristics of double-layered porous micropolar fluid lubricated journal bearing

Numerical simulation of the dynamic fluid–solid coupling in journal bearing with the effect of surface topography in consideration

Approximate Numerical Solution of Hydrodynamic Gas Journal Bearings

Thrust Porous Bearing with Rough Surfaces Lubricated by a Rotem-Shinnar Fluid

Theoretical Analysis of Orifice Compensated Symmetric and Asymmetric Hydrostatic Non-Recessedjournal Bearings Under Couple Stress Lubricants

Effect of pocket orientation on four pocket hybrid journal bearing operating with piezo-viscous polar lubricant

On the Dynamic Characteristics of Rough Porous Inclined Slider Bearing Lubricated with Micropolar Fluid

Performance Comparison of Newtonian and Non-Newtonian Fluid on a Heterogeneous Slip/No-Slip Journal Bearing System Based on CFD-FSI Method