Abstract:As a newly emerged active flow control technique, micro blowing/suction has shown a great potential in reducing the skin friction of turbulent flows. Throughout comprehensive analyses of active flow control of micro blowing/suction devices for a NACA0015 airfoil by means of CFD technique, the effects on various characteristics such as lift and drag coefficients and separation areas are investigated in this study. The control devices were placed at 12%c, 30%c and 70%c from the leading edge (c is the chord length of the airfoil), respectively. The corresponding trends of flow separation control at these locations were analyzed with a varied range of angle of attacks (AOA). The two- and three-dimensional incompressible unsteady detached-eddy simulation (DES) was used, along with the k-e turbulence model, in solving the flow problem. The numerical computational results have demonstrated that: (1) Installing micro blowing/suction devices near the separation point is more efficient, as blowing can mix the jet flow and the incoming flow to energize the turbulent kinetic energy and suction can mitigate the flow of low turbulent kinetic energy, which leads to a result of reducing the separation. (2) Suction sometime has more effective influence than blowing, when the flow control devices are placed at 12%c and 30%c. When the control device is placed at 70%c, the effects of lift enhancement and drag reduction are almost the same regardless of blowing and/or suction method. When the AOA is less than 18°, both methods can achieve the goal of lift enhancement and drag reduction. When the AOA is larger than 18°, neither blowing nor suction is efficient. (3) The 3-D numerical simulation shows that the vortex structure evolves from a 2-D pattern near the separation point to a 3-D pattern in the downstream. However the characteristics of flow separation control over a 3-D airfoil simulation agrees well with 2-D numerical results. (4) Blowing at 30%c can move the separation point downstream from 70%c to 80%c at AOA=11°.

Modal Reduction of Synthetic Jet Actuator Based Separation Control With Spectral POD

Analysis Of Synthetic Jet Piv Experiment Based On Dynamic Mode Decomposition

Effects of Micro Blowing/suction Flow Control Devices on a NACA0015 Airfoil

Flow Reconstructions and Aerodynamic Shape Optimization of Turbomachinery Blades by POD-based Hybrid Models

Aerodynamic and Acoustic Behavior of a Finite Span Wing Equipped with Synthetic Jet Actuator

Modal Analysis of Compressor Cascades with Sweeping Jet Actuator and Pulsed Jet for Active Flow Control Based on Large Eddy Simulation

Synthetic Jet Control on the Propulsion Behavior of a Foil in Plunge-pitch Motion

Modulation of driving signals in flow control over an airfoil with synthetic jet

Enhancement of aerodynamic performance of a heaving airfoil using synthetic-jet based active flow control

Numerical Analysis Of Active Flow Control Around Airfoil By Synthetic Jet Technology In Low Reynolds Number

High-speed micro-actuation in a supersonic dual-stream jet flow

Active Flow Control in an S-shaped Duct at Mach 0.4 Using Sweeping Jet Actuators

Wind-Tunnel-in-the-Loop Exploration and Optimization of Active Flow Control Parameters

High-speed microactuation in a supersonic dual-stream jet flow

Modal Analysis of EHD Jets Through the SVD-based POD Technique

PCA-Kriging-Based Oscillating Jet Actuator Optimization and Wing Separation Flow Control

Numerical study of flow separation control over a circular hump using synthetic jet actuators

Lagrangian analysis of mass transport and its influence on the lift enhancement in a flow over the airfoil with a synthetic jet

Spanwise Control Authority of Synthetic Jets on a Stalled Airfoil

Aerodynamic Characteristics of a Normal Hovering Foil with Synthetic Jet Actuation

Flow Control with Synthetic Jets on two Tandem Airfoils Using Machine Learning