Three‐dimensional P‐wave velocity structure modelling of the Middle and Lower Reaches of the Yangtze River Metallogenic Belt: Crustal architecture and metallogenic implications

Anguo CHEN,Qingtian LÜ,Taofa ZHOU,Jianguo DU,Juan DING,Jiayong YAN,Zhitang LU

DOI: https://doi.org/10.1111/1755-6724.14603

2020-12-08

Abstract:In this study, we compiled and analyzed 69310 P‐wave travel‐time data from 6639 earthquake events. These events (M ≥ 2.0) occurred from the 1980s to June 2019, and were recorded at 319 seismic stations (China Earthquake Networks Center) in the study area. We adopted the double‐difference seismic tomographic method (tomoDD) to invert the 3‐D P‐wave velocity structure and constrain the crust‐upper mantle architecture of the Middle and Lower Reaches of the Yangtze River Metallogenic Belt (MLYB). A 1‐D initial model extracted from wide‐angle seismic profiles was used in the seismic tomography, which greatly reduced the inversion residual. Our results indicate that reliable velocity structure of the uppermost mantle can be obtained when Pn is involved in the tomography. Our results show that: (1) the pattern of the uppermost mantle velocity structure corresponds well with the geological partitioning: an nearly E‐W‐trending low‐velocity zone is present beneath Dabie Orogen, in contrast to mainly NE‐trending low‐velocity anomalies beneath Jiangnan Orogen. They suggest the presence of thickened lower crust beneath the orogens in the study area. On the contrary, the Yangtze and Cathaysia blocks are charaterized by relatively high‐velocity anomalies; (2) Both the ultra‐high‐pressure (UHP) metamorphic rocks in Dabie Orogen and the low‐pressure metamorphic rocks in the Zhangbaling dome are featured by high‐velocity anomalies. The upper crust in Dabie Orogen is characterized by a low‐velocity belt sandwiched between two high velocity zones in the horizontal direction, with discontinuous low‐velocity layers in the middle crust. The keel of Dabie Orogen is mainly preserved beneath its northern section. We inferred that the lower crustal delamination may have mainly occurred in the southern Dabie Orogen, which caused the mantle upwelling responsible for the formation of the granitic magmas emplaced into the middle crust as the low‐velocity layers observed there. Continuous deep‐level compression likely squeezed the granitic magma upward to intrude the upper crustal UHP metamorphic rocks, forming the "sandwich" velocity structure there; (3) high‐velocity updoming is widespread in the crust‐mantle transition zone beneath the MLYB. From the Anqing‐Guichi orefield northeastward to the Luzong, Tongling, Ningwu and Ningzhen orefields, high‐velocity anomalies in the crust‐mantle transition zone increase rapidly in size and areally distributed. The updoming also exists in the crust‐mantle transition zone beneath the Jiurui and Edongnan orefields, but the high‐velocity anomalies are mainly stellate distributed. The updoming high‐velocity zone beneath the MLYB generally extends from the crust‐mantle transition zone to the middle crust, differeent from the velocity structurein the upper crust. The upper crust beneath the Early Cretaceous extension‐related Luzong and Ningwu volcanic basins are featured by high velocity, in contrast to the low velocity anomalies beneath the Late Jurassic to Early Cretaceous compression‐related Tongling orefield. The MLYB may have undergone a compressive to extensional transition during the Yanshanian (Jurassic‐Cretaceous) period, during which extensive magmatism occurred. The near mantle‐crustal boundary updoming was likely caused by asthenospheric underplating at the base of the lower crust. The magmas may have ascended through major crustal faults, underwent AFC (assimilation and fractional crystallization) processes, emplaced in the fault‐bounded basins or Paleozoic sequences, and eventually formed the many Cu‐Fe polymetallic deposits there.