Abstract:At present, there is a great interest in the development of new airfoils for wind turbines and high-lift wings of unmanned aerial vehicles (UAV). The requirements for such airfoils differ from conventional aircraft airfoils, because of structural reasons and extreme operating conditions. So, wind turbine airfoils operate frequently under fully separated flow when stall is used for power regulation at high wind speeds. At the same time design of airfoils for wings UAV poses the problem of availability of high-lift at low Reynolds number. Modern airfoils are to a large extent developed from numerical methods. However, the complex flow conditions such as separation at high angles of attack, laminar separation bubbles and the transition from laminar to turbulent flow are difficult to predict accurately. Hence, testing of airfoils at a two-dimensional condition is an important phase in airfoil design. The development and validation of a 2D testing facility for investigation of single and multi-element airfoils in the wind tunnel Т-102 with open test section are considered in this article. T-102 is a continuous-operation, closed-layout wind tunnel with two reverse channels. The test section has an elliptical cross-section of 4 ×2,33 m and a length of 4 m. Two big flat panels of the L × H=3 ×3,9 m size installed upright on balance frame aligned with the free stream are used for simulating two-dimensional flow in the tunnel test section. The airfoil section in the layout of a rectangular wing is mounted horizontally between flat panels with minimum gaps to ensure 2D flow conditions. The aerodynamic forces and pitch moment acting on the model were measured by wind tunnel balance. To determine boundary corrections for a new test section of wind tunnel, the experimental investigation of three geometrically similar models has been executed. The use of boundary corrections has provided good correlation of the test data of airfoil NACA 6712 with the results obtained from the wind tunnel except for lift and drag coefficient values at high angles of attack.

Three-dimensional visualization of flow pattern near transport airplane model with operating propellers in wind tunnel

3D flow visualization and tomographic particle image velocimetry for vortex breakdown over a non-slender delta wing

Features of flow around transport aircraft model with running propellers by modelled engine failure in wind tunnel

Vortical Structures over a Generic Tailless Chined Forebody–Delta Wing

SIMULATION OF 2D FLOW AROUND OF AIRFOILS AT LOW-SPEED WIND TUNNEL WITH OPEN JET TEST-SECTION

Numerical and experimental study of the aerodynamics of a civil-aircraft model at high angles of attack and during rotation

Investigation Of The Influence Of Distributed Propulsion On The Structure Of A Separated Flow Around A Trapezoidal Model Of A Flying Wing

Aerodynamic Interaction Mechanisms in Typical Wingtip-Mounted Tractor Propeller Configurations

Visualizing three-dimensional effects of synthetic jet flow control

Experimental Investigation of the Flow Structure over a Delta Wing Via Flow Visualization Methods

Features of the flow structure in the boundary layer of a V-shaped flying wing model with controls and a distributed electric propulsion

3-D Flow Characteristics Of Asymmetric Vortices Over An Ogive-Cylinder And Its Structural Model

Reliable method of aerodynamic analysis using computational fluid dynamics and scaled models in the development process of a Very Light Airplane

Experimental Study on the Three-Dimensional Wake Structure of the DrivAer Standard Model

Experiment study of propulsion-induced flow on aircraft aerodynamics

Extended Study of Full-Scale Wind Tunnel Test and Simulation Analysis Based on DrivAer Model

Laminar Transition over Airfoil: Numerical Simulation of Turbulence Models and Experiment Validation

Wind Tunnel Testing and Modeling Implications of an Advanced Turbine Cascade

On the formation of three-dimensional flows over finite-aspect-ratio wings under tip effects

Wind Tunnel Experiment and Numerical Simulation of Secondary Flow Systems on a Supersonic Wing