Abstract:Among fuel cells, the direct methanol fuel cell (DMFC) has attracted great attention and has been considered a very promising power source because of the ease of methanol transportation and its high energy density. A major limiting factor hindering DMFC’s commercial application is the poor catalytic performance in the anode (methanol oxidation reaction). The methanol oxidation reaction (MOR) requires (OH-) from water dissociation as an oxygen donor for the reaction; however, the slow water dissociation on Pt limits the rate of MOR. In addition to the sluggish catalytic activity, the other major impediment for Pt catalysts is the generation of carbon monoxide (CO) during the MOR process.In order to improve the catalytic performance of MOR catalysts, a variety of catalyst design strategies have been devised. The interesting way of carrying out the MOR catalytic process is the non-CO pathway which takes place on Pt-Au bimetallic catalysts, thus eliminating CO poisoning. However, the overall activity of Pt-Au alloys in MOR is relatively low, which ultimately limits the application of Pt-Au catalysts. In this study, a nanoporous (np) Au-Cu-Pt thin-film catalyst with a fine structure and tunable composition is synthesized by using a facile method involving successive electrodeposition and de-alloying. SEM, SEM-EDX and ICP have been used for morphology characterization and composition assessment. Pb under-potential deposition (UPD), H UPD and CO stripping tests have been employed to determine the electrochemical active surface area (ECSA) and to probe the Pt active sites specifically. Also, cyclic voltammetry (CV) tests have been performed to assess the catalytic performance in MOR. Finally, long-term CV and chronoamperometry (constant potential) tests have been used to study and evaluate the durability of accordingly synthesized catalyst for MOR. The prepared np Au-Cu-(8% in the precursor alloy)Pt catalyst exhibits outstanding mass and specific activity toward the MOR, which is approximately six- and nine-times higher than the activity of a commercial Pt/C(40%) counterpart, respectively. A negative 75 mV onset potential shift upon the MOR anodic scan on the np Au-Cu-(8 %)Pt catalyst in comparison with Pt/C(40%) corroborates its higher catalytic activity. Furthermore, the alloy catalyst demonstrates better durability than the Pt/C(40%) counterpart in a three-hour constant potential test and exhibits full post-factum recovery of its cycling activity. In addition, it retains more than 60% of its original activity after 3000 cycles of an accelerated degradation test. Reference: Xie, Y., Li, C., Razek, S.A., Fang, J. and Dimitrov, N., 2020. Synthesis of Nanoporous Au− Cu− Pt Alloy as a Superior Catalyst for the Methanol Oxidation Reaction. ChemElectroChem, 7(2), pp.569-580.

Influence of electrodeposition techniques and parameters towards the deposition of Pt electrocatalysts for methanol oxidation

Tuning Surface Structure of Pd3Pb/PtnPb Nanocrystals for Boosting the Methanol Oxidation Reaction

Study on Electrodeposition of Bimetallic Microparticle Electrode and Its Electrocatalytic Oxidation for Methanol

Facile Synthesis of Ternary PtPdCu Alloy Hexapods As Highly Efficient Electrocatalysts for Methanol Oxidation

Methanol Oxidation at Platinum Coated Black Titania Nanotubes and Titanium Felt Electrodes

Enhanced Methanol Oxidation Using Polymer-Incorporated Rough Pt Electrodes

Crucial Size Effects of Atomic-Layer-deposited Pt Catalysts on Methanol Electrooxidation

PEDOT-embellished Ti 3 C 2 Tx nanosheet supported Pt–Pd bimetallic nanoparticles as efficient and stable methanol oxidation electrocatalysts

Influence of Metal Oxides on Pt Catalysts for Methanol Electrooxidation Using Electrochemical Impedance Spectroscopy

Nanoporous Au-Cu-Pt As a Superior Electro-Catalyst for the Methanol Oxidation Reaction

Tailoring the electronic structure of PtNi nanoalloy for boosting methanol electro-oxidation reaction

Platinum Supported on Early Transition Metal Carbides: Efficient Electrocatalysts for Methanol Electro-Oxidation Reaction in Alkaline Electrolyte

Titanium carbide nanoparticles supported Pt catalysts for methanol electrooxidation in acidic media

Superior Catalytic Performance and CO Tolerance of Ru@Pt/C-TiO2 Electrocatalyst Toward Methanol Oxidation Reaction

Synergistic Electronic Pull of Graphene Oxide Supported Pd Nanoparticles on Enhancing Catalytic Activity of Electro Deposited Pt Nanoparticles for Methanol Oxidation Reaction.

Facile Synthesis of PtP2 Nanocrystals As Highly Active Electrocatalysts for Methanol Oxidation.

A Facile Preparation of Novel Pt-decorated Ti Electrode for Methanol Electro-Oxidation by High-Energy Micro-Arc Cladding Technique

Structure-activity relationship of tri-metallic Pt-based nanocatalysts for methanol oxidation reaction

Recent advances in two-dimensional Pt based electrocatalysts for methanol oxidation reaction

PtRu mesoporous nanospheres as electrocatalysts with enhanced performance for oxidation of methanol

Targeted Growth of Pt on 2D Atomic Layers of Ni-Al Hydroxide: Assembly of the Pt/Exfoliated Ni-Al Hydroxide Sheet/graphene Composite As Electrocatalysts for Methanol Oxidation Reactions