Abstract:<p class="a-plus-plus">This paper aims at studying on the fracture behavior due to crack propagation at compact tension specimen composed of inhomogeneous metal materials with holes near main crack. In this study, the experiments were performed for compact tension specimens produced by the mutual bonding metals of stainless steel and brass, and the simulation analyses to verify these experiments were conducted. When the preceding study results are confirmed, the design of structures with no holes near a crack becomes more durable on the strength aspect than the design of structures with holes existing near the crack. The design for highest strength is possible if no holes are pierced in inhomogeneous metal materials bonded with adhesives. On the other hand, in case the holes due to additional bolt and rivet fastening must be pierced, the most similar tendency to that of materials without holes is exhibited when the hole center is placed by about 20 mm from the crack tip. A great difference in strength occurs according to the hole position near the main crack at inhomogeneous metal materials bonded with adhesives. So, the design considering this aspect is deemed important. The data for different positions where the crack propagations occur can be confirmed at analysis and experimental results. Therefore, the changes inside the material that are actually difficult to confirm due to the crack growth characteristics at inhomogeneous materials can be expected through an analysis. The fracture behavior of inhomogeneous metal materials bonded by adhesives was investigated through the experiment and analysis. The basic data through this study could be secured at contributing to the developed design of light-weight composite materials as well as bonding the technology for mutually different materials.</p>

A study on the fracture characteristics of tapered double cantilever beams made of heterogeneous composites with adhesive interfaces

Nonlinear Fracture Analysis of Delamination Crack Jumps in Laminated Composites

Fatigue Performance of Prefabricated Composite T‐beams under Cyclic Overloading: an Experimental Study

Feasibility and Performance of Novel Tapered Iron Bolt Shear Connectors in Demountable Composite Beams

Analysis of the adhesively bonded composite double cantilever beam specimen with emphasis on bondline constraint, adherend through-thickness flexibility and fracture process zone relative size

A study on fracture behavior due to crack propagation at compact tension specimen composed of inhomogeneous metal materials with holes near crack

Experimental investigation of CNT effect on curved beam strength and interlaminar fracture toughness of CFRP laminates

Investigation on the Stable and Stick-Slip Crack Propagation Behaviors in Double Cantilever Beam Test

Dynamic Failure Analysis Of Bimaterial Beam With Crack-Tip Terminating Interface

Experimental and Numerical Study of Curved SFRC and ECC composite beams with Various Connectors

Experimental and numerical investigation on damage mechanism in asymmetric tapered laminates under tensile loading

Investigations on the Mechanical Properties of Composite T-Joints with Defects under Bending Loading

A Nonlinear Theory for CFRP Strengthened Aluminum Beam

Experimental Investigation and Analysis on Flexural Performance of Functionally Graded Composite Beam Crack-Controlled by Ultrahigh Toughness Cementitious Composites

Improvement of the flexural and cracking behavior of RC beams using ultra-high toughness cementitious composites(I):theoretical analysis

An Investigation on Mechanical Behavior of Tooth-Plate-Glass-Fiber Hybrid Sandwich Beams

Mode I fracture toughness of asymmetric metal-composite adhesive joints

Theoretical analysis on bending behavior of functionally graded composite beam crack-controlled by ultrahigh toughness cementitious composites

Fabrication and Bending Behavior of Thermoplastic Composite Curved Corrugated Sandwich Beam with Interface Enhancement

Study on Debonding Failure Behavior of RC Beams Combination Strengthened with Carbon Fiber Reinforced Polymer and Steel Plates

A Novel Rectangular-Section Combined Beam of Welded Thin-Walled H-Shape Steel/Camphor Pine Wood: The Bending Performance Study