Effect of Cutting Temperature on Phase Transformation in Cutting of NiTi Alloy

Hao Yang,Katsuhiko Sakai,Hiroo Shizuka,Kunio Hayakawa,Tetsuo Nagare
DOI: https://doi.org/10.1115/lemp2020-8566
2020-09-03
Abstract:Abstract In this study, the effect of cutting temperature on phase transformation in cutting of room temperature austenitic NiTi alloy was investigated by X-ray diffraction (XRD) and temperature measurements. Results from XRD reveals that after cutting process, the phase state of work material near the machined surface transformed from austenite to martensite at relatively low cutting speed conditions while the phase state of work material did not undergo any form of transformation at the highest cutting speed condition. Temperature measurement results measured with temperature indicating paint showed that the maximum temperature of work material near the machined surface in cutting process exceeded the Md temperature at the highest cutting speed condition. However, there was no phase transformation observed in cutting chips after cutting at all cutting speed conditions as the temperature of cutting chips was much higher than the Md temperature under all cutting speed conditions.
What problem does this paper attempt to address?