Abstract:The Doppler Asymmetric Spatial Heterodyne (DASH) spectrometer is a new type of high-resolution spectral measurement instrument that has received widespread attention in re-cent years. However, in previous ground experiments, laser sources were often used so that without exposing the premise and limitations of its high measurement accuracy. Therefore, this article provides a detailed introduction to the measured physical quantity transfer process, de-rives the constraints of DASH spectral velocimetry by discrete sampling, spectral offset analysis, and phase deviation analysis methods. Furthermore, it clarifies the impact of back-end signal processing methods on velocity measurement resolution and the range of algorithm errors. With a "spring model" of interference fringes is proposed, which not only provides mathematical model support for the superiority of using phase shift measurement methods to invert Doppler velocity, but also explains the improvement reason of the "asymmetric" structure relative to the original symmetric spatial heterodyne spectrometer. Meanwhile, based on the simulation values of the set parameters, the measurement resolution improvement factor of the interferometric phase measurement method relative to the spatial frequency measurement method is quantitatively calculated. In the field of astronomical remote sensing, due to stellar spectra lack of the monochromaticity and ideal spectral shape of laser sources used in ground experiments, it is necessary to consider whether the specific characteristics of the incident spectrum meet the amplification effect and effective range on the measured physical quantity transmission chain. It provides a reference for the practical application of the DASH spectral velocimetry technology.

The effect of spot size on quality factor of Laser Doppler Velocimeter

A quadrant detector based laser alignment method with higher sensitivity

Quality Weight Based on Log Modulation Amplitude for Fringe Analysis During Optical Fringe Measurement

Smoothing of Small On-Target Spots Produced by Frequency-Tripled Beams Using Lens Array and Spectral Dispersion

Effect of Speckle Pattern on Laser Doppler Velocimeters by Varying Angle Between the Laser Beam Direction and the Velocity

Research on laser spot location accuracy of low-power laser diode source applied to high precision laser measurement system

Laser Spot Center Detection and Comparison Test

Analysis of the Effects on Ultra-Short Laser Pulse Beam Quality Caused by Errors in Optical Systems

A New Pattern Quality Assessment Criterion and Defocusing Degree Determination of Laser Speckle Correlation Method

Accuracy of Velocity Measurement Based on Self-mixing Laser Doppler Velocimer Setup

Effect of Structure and Size of Laser Spot on Speckle Contrast in Laser Scanning Display

Effect of Angle of Incidence on Self-Mixing Laser Doppler Velocimeter and Optimization of the System

Study on Techniques in LDV Pipe Velocity Measurement

Influence of Stray Light in Low Blind Zone on Signal Quality of Lidar System

Scanning Measurement Method of Dispersion Mini-spot by Quadrant Photodetector

Analysis of Velocimetry Processing Method Based on Doppler Asymmetric Spatial Heterodyne Spectrometer

Numerical simulation and characterization of speckle noise for laser Doppler vibrometer on moving platforms (LDVom)

Quality of Resonant Microbeam in Vacuum

A novel Laser Doppler Velocimeter based on a liquid lens

Spot Effect in Optical Constant Characterization of Thin Films Fabricated by Ion Beam Sputtering

Real-Time Measurement of Beam Quality Factor M~2 Based on Diffraction Gratings