Abstract:Shear failure of bedding slopes along weak zones is the main failure mechanism of the Layue landslide. To investigate the seismic dynamic response and destabilization failure mode of rock slopes with laminated fracture structures, a two-dimensional shaking table test with different ground motion inputs was performed, taking into consideration a variety of factors, such as the input seismic wave type and amplitude. The results show that the ground shaking characteristics and geological structure of the slope are the decisive factors in determining the seismic dynamic stability and failure mode of the slope. The horizontal dynamic response of the slope has an obvious elevation amplification effect and topographic effect, and the elevation has less influence on the vertical dynamic response of the slope. The ground motion amplification effect is related to the mechanical strength of the structural surface, the waveform of seismic waves, and the spectral characteristics. The sine wave has a more significant influence on the amplification effect of the slope than the natural wave. The slope cracks are initiated and propagate at the weakest part depending on the dominant structural surface and trace to the joint surface to form creep sections and locking sections. The strength parameter of the joint surface weakens under the action of geological agents, which results in two failure modes of the slope: the forward failure mode and the backward failure mode. The former refers to the potential slip belt lap through from the trailing edge to the front edge, where the sliding mass is cut out from the high position. The latter refers to the potential slip belt lap through the front edge to the trailing edge, and the sliding mass breaks down and is destroyed. Through a unique adaptive device, the seismic anchor cable can coordinate the deformation of the anchor cable with the rock-soil body, which can reduce the risk of a slope earthquake disaster.

Large deformation dynamic analysis of progressive failure in layered clayey slopes under seismic loading using the particle finite element method

Multiscale Modeling of Seepage-Induced Suffusion and Slope Failure Using a Coupled FEM–DEM Approach

Modeling of Initial Stresses and Seepage for Large Deformation Finite-Element Simulation of Sensitive Clay Landslides

Large deformation slope failure — A perspective from multiscale modelling

Large Deformation Finite Element Analysis on Excavated Slopes

Numerical Investigation on Dynamic Response and Failure Modes of Rock Slopes with Weak Interlayers Using Continuum-Discontinuum Element Method

Elastoplastic strain localization analysis of soil slope

Large deformation and failure analysis of river embankments subjected to seismic loading

Numerical investigations of retrogressive failure in sensitive clays: revisiting 1994 Sainte-Monique slide, Quebec

Towards Physics-Based Large-Deformation Analyses of Earthquake-Induced Dam Failure

Seismic cumulative failure effects on a reservoir bank slope with a complex geological structure considering plastic deformation characteristics using shaking table tests

Modeling the large deformation failure behavior of unsaturated porous media with a two-phase fully-coupled smoothed particle finite element method

Large deformation failure analysis of the soil slope based on the material point method

Seismic slope stability and failure process analysis using explicit finite element method

Analysis of the seismic dynamic response and failure mode of the Layue landslide

Seismic stability and failure mode of the slope containing a two-pile foundation

Progressive Failure Behavior of Pile-Reinforced Clay Slopes under Surface Load Conditions

Development of an SPH-based method to simulate the progressive failure of cohesive soil slope

Finite element simulation of an excavation-triggered landslide using large deformation theory

Material point method for large-deformation modeling of coseismic landslide and liquefaction-induced dam failure

Dynamic stability analysis of jointed rock slopes using the combined finite-discrete element method (FDEM)