Abstract:Organic photovoltaic solar cells can offer advantages of being mechanically flexible and durable, large area devices, lightweight, made from a diversity of materials and low-cost fabrication. Their efficiency is, however, still too low for commercial exploitation. Empirical observations reveal that polymer–fullerene (P3HT:PCBM) based solar cell performance depends on thermal annealing processes employed, especially the annealing temperatures and durations. The annealing parameters are known to influence the energetics and kinetics of the blending process or morphology, but the associated physics is not fully understood. In this work, current density–voltage characteristics of P3HT:PCBM bulk heterojunction organic solar cells, thermally annealed at different temperatures, 65–160 °C post fabrication, were investigated under dark and illuminated conditions, and compared to their as-cast counterparts. In certain electrical regimes, as-cast devices showed higher values of current density in comparison to the corresponding annealed devices. Such performance was attributed to air-borne chemical doping of the as-cast semiconductor layer, which creates electrically conductive percolation pathways within the as-cast devices. We propose that annealing of semiconductors must be a two-step process, which first initiates decrease in conductivity, followed by its increase. As-cast devices P3HT–PCBM bulk heterojunction solar cells prepared under atmospheric conditions were observed to have comparatively superior photovoltaic performance in comparison to thermally annealed devices. The efficiency drop in the annealed counterparts is attributed to dedoping due to thermal annealing. An annealing temperature of ~ 140 °C was found to be optimum for power conversion efficiency in the bulk heterojunction, 1:1 by mass, P3HT:PCBM based solar cells.

Review on performance analysis of P3HT:PCBM-based bulk heterojunction organic solar cells

Organic Solar cells: Recent advances and Challenges

Solution Sequential Deposition Pseudo-Planar Heterojunction: an Efficient Strategy for State-of-Art Organic Solar Cells

Recent Advances in Intermixed Phase of Organic Solar Cells: Characterization, Regulating Strategies and Device Applications

Dark and illuminated J(V) characteristics of thin layered bulk heterojunction P3HT:PCBM sandwich solar cells after thermal treatment

Optimization of Bulk Heterojunction Organic Photovoltaics

Stability of organic solar cells: toward commercial applications

Advances in organic solar cells: Materials, progress, challenges and amelioration for sustainable future

Powering the Future: A Critical Review of Research Progress in Enhancing Stability of High‐Efficiency Organic Solar Cells

Progress Towards Stable Organic Solar Cells

A Comprehensive Review of PM6:BTP-eC9 Based Non-Fullerene Organic Solar Cells

Recent Progress in Organic Solar Cells: A Review on Materials from Acceptor to Donor

Stability Of Organic Solar Cells: Challenges And Strategies

A Review of the Improvements in the Performance and Stability of Ternary Semi-Transparent Organic Solar Cells: Material and Architectural Approaches

A Critical Review on Efficient Thick‐Film Organic Solar Cells

Review—Conjugated Polymer Photovoltaic Materials: Performance and Applications of Organic Semiconductors in Photovoltaics

Industrial viability of single-component organic solar cells

Advantages, challenges and molecular design of different material types used in organic solar cells

Organic Solar Cells; Fabrication Technique, Operating Principle, Characterization and Improvement

Achieving over 16% Efficiency for Single-Junction Organic Solar Cells

Recent Advances in Stability of Organic Solar Cells