Abstract:Activated carbon (AC) exhibits limited adsorption capacity for pollutants. Conversely, titanium dioxide (TiO2) demonstrates excellent photocatalytic performance, making it a popular choice for pollutant removal. This study investigates the removal of methylene blue (MB) dye from wastewater using AC, TiO2@AC-2, and TiO2@AC-10 samples via adsorption and photocatalysis. The Energy Dispersive analysis of X-rays (EDAX) has confirmed the presence of Ti, C and O in the prepared samples without any impurities. All the diffraction peaks in X-ray diffractograms indicated the presence of pure anatase TiO2 (tetragonal phase) with no evidence of any other phase. Fourier transform infrared spectroscopy (FTIR) analysis identified a peak around 545 cm−1 in the TiO2@AC-2 sample, indicative of O-Ti-O stretching vibrations. This peak shifted to 602 cm−1 in the TiO2@AC-10 sample. Raman spectroscopy confirmed the presence of carbon (D and G bands) at 1310-1347 cm−1 and 1582-1597 cm−1. Additionally, characteristic Raman active bands for anatase TiO2 were observed at 154 cm−1 (Eg), 204 cm−1 (Eg), 398 cm−1 (B1g), 508 cm−1 (A1g), and 628 cm−1 (Eg). N2 adsorption-desorption isotherms revealed a mesoporous structure for all samples (AC, TiO2@AC-2, and TiO2@AC-10) with hysteresis loops, indicating pores ranging from 2 nm to 50 nm in diameter. Reflectance spectra of TiO2@AC-2 and TiO2@AC-10 displayed absorption edges at 368 nm and 385 nm, respectively, corresponding to a direct band gap of approximately 3.22 eV. Subsequently, these prepared samples were effectively employed for the removal of methylene blue (MB) dye from wastewater utilizing both adsorption and photocatalysis method. Under dark conditions, 20 mg/L doses of TiO2@AC-2 and TiO2@AC-10 resulted in 60% and 36% dye adsorption within 60 minutes respectively. In the presence of UV radiation, the degradation of dye was observed to be 74% and 95% by TiO2@AC-2 and TiO2@AC-10 respectively. This observation indicates that TiO2 nanoparticles along with AC leads to enhanced photocatalytic activity. The Langmuir-Hinshelwood model reveals lower rate constants for AC compared to the composite samples. This is likely because AC lacks inherent catalytic activity, requiring UV light to trigger adsorption. Conversely, TiO2@AC-10 exhibits the highest rate constants (K1 = 24.25 × 10-3 min−1 and K2 = 82.71 × 10-3 min−1), aligning with its higher TiO2 content confirmed by EDAX analysis. This suggests a significantly faster photocatalytic rate and superior degradation efficiency, even at a low sample concentration (20 mg/L).

Equilibrium, kinetic and mechanism studies on adsorption of textile disperse dye from aqueous solution onto TiO2 in the presence of ultrasound and rare earth ions

Dye degradation and molecular docking mechanism of Terminalia catappa mediated mesoporous titanium dioxide nanoparticles

Facile synthesis of TiO2@ZnO nanoparticles for enhanced removal of methyl orange and indigo carmine dyes: Adsorption, kinetics

Potential of Titanium Dioxide to Remove Bromothymol Blue (BTB) in Aqueous Solution by Batch Mode Adsorption–Kinetic, Isotherm and Thermodynamic Studies

GLYCEROL-MEDIATED SYNTHESIS OF NITROGEN-DOPED TiO2 WITH EXCELLENT ADSORPTION AND PHOTOCATALYTIC ACTIVITY FOR REMAZOL RED DYE REMOVAL

Studying removal of anionic dye by prepared highly adsorbent surface hydrogel nanocomposite as an applicable for aqueous solution

Photocatalytic Degradation of Dye Acid Orange Seven on Titanium Dioxide Photocatalysts Immobilized on Stainless Steel Coated Layers: Role of Catalyst Loading and Ultrasonic Treatment

Trinary Component Adsorption of Methylene Blue, Methyl Orange, and Methyl Red from Aqueous Solution Using TiO2/Activated Carbon

In situ synthesis of novel peroxo-functionalized Ti3C2Tx adsorbent for aqueous pollutants removal: Role of oxygen-containing terminal groups

Insight into the effect of surface carboxyl and amino groups on the adsorption of titanium dioxide for acid red G

Simultaneous photocatalytic removal of organic dye and heavy metal from textile wastewater over N-doped TiO2 on reduced graphene oxide

Nanosized silica–titanium oxide as a potential adsorbent for C.I. Acid Yellow 219 dye removal from textile baths and wastewaters

Interface engineering of Ti-MOFs: Adsorption of anionic, cationic and neutral dyes in wastewater

Adsorption of Azo Dye Onto TiO2 Nanoparticles Prepared by a Novel Green Method: Isotherm and Thermodynamic Study

Cationic surfactant modified iron nanoparticles for removal of orange II in batch mode: Kinetics, isotherms, mechanistic, and thermodynamic approach

Kinetic study of adsorption and photocatalytic degradation of methylene blue dye using TiO2 nanoparticles with activated carbon

Removal of iodate from aqueous solution using diatomite/nano titanium dioxide composite as adsorbent

Effects of ultrasound waves intensity on the removal of Congo red color from the textile industry wastewater by Fe3O4@TiO2 core-shell nanospheres

Adsorptive removal of azo dye using magnetic nanoparticles: an insight into equilibrium, kinetics and thermodynamic studies

Removal of a Cationic Dye by Adsorption / Photodegradation Using Electrospun PAN / O-MMTComposite NanofibrousMembranes Coated with TiO 2

Comparative studies of the Fe3+/2+-UV, H2O2-UV, TiO2-UV/vis systems for the decolorization of a textile dye X-3B in water.