Abstract:Background, aim and scope: Salt efflorescences markedly contribute to the alteration and deterioration of building material, in this case the Villamayor Sandstone of the facades in the Old Town of Salamanca, Spain (United Nations Educational, Scientific and Cultural Organization world cultural heritage site). A better understanding of the mechanisms of salt formation and the involved elements would allow more precise measures in monument conservation. The magnesium which is required for the salt precipitation originates from selective processes of hydrolysis. The source of sulphate, however, is presently not as clear. Identifying the source of the sulphur was the main goal of this research. Isotope ratio measurement of delta(34)S and delta(18)O was used to clarify the origins of Mg sulphate salts. Materials and methods: A total of 56 Mg sulphate samples were collected in two different seasons (July and November 2005) from monuments of the Old Town of Salamanca. These sampled salt efflorescences were analysed for delta(34)S and delta(18)O by mass spectrometry. A 'dual-inlet' type by VG Isotech was used for delta(34)S and continuous flow type Isoprime by GV Instruments for delta(18)O. Samples were measured in triplicates and standard material was analysed for quality control. Results: delta(34)S values range between 3.6 per thousand and 15.4 per thousand with a median value of 10.2 per thousand for the July samples and of 10.1 per thousand for November samples. The results of the sulphur ratios hint towards a bimodal distribution (with modes at delta(34)S = 6 per thousand and 12 per thousand) for winter samples, which is less obvious during summer. delta(18)O values range from 7.1 per thousand to 41.1 per thousand. However, most values range from 7.1 per thousand to 20.8 per thousand, whereas only few summer samples show outliers towards higher delta(18)O values. The median delta(18)O value for July samples is 15.5 per thousand and for November samples 14.6 per thousand. Discussion: The isotopic ratios of the analysed sulphate samples were compared with values of possible source materials. Sulphur sources in the case of Salamanca are barites from the Villamayor Sandstone itself, sea spray, sulphides from regional rocks, biogenic sulphur (soil, avian excreta), as well as sulphur from anthropogenic sources such as building materials (especially mortar) or traffic exhaust. Salamanca is a representative site for non-industrial cities with no heavy industry and thus, there are no significant SO(2) emissions from industry. Conclusions: Based on the measured isotopic ratios, it was ascertained that more than one sole sulphur source is present. However, based on additional information about the source material and possible transport ways, some sources could be excluded whereas others only played a minor role. Finally, there is strong indication that the main sulphur source is atmospheric pollution and the exhaust emissions from vehicles in particular, while mortar as building material also contributes to a minor extent. The delta(18)O values support this hypothesis. Moreover, the reported delta(18)O values are a strong indicator of the secondary nature of the Mg sulphates. Isotope ratio measurement and especially the combined use of delta(34)S and delta(18)O values have proven to be a good instrument in clarifying the origin of salt efflorescences on buildings. Recommendations and perspectives: Further studies should investigate more closely the isotopic composition of atmospheric aerosols in Salamanca in order to get a more detailed knowledge about the main sulphur sources, as well as to quantify the relation between the isotopic values and the amount and mineralogical form of the salts.

The Combined Use of Ion Chromatography and Scanning Electron Microscopy to Assess Salt-affected Mineral Materials in Cultural Heritage

The coordinated use of synchrotron spectroelectrochemistry for corrosion studies on heritage metals

The identification of organic additives in traditional lime mortar

A new approach to assess the chemical composition of powder deposits damaging the stone surfaces of historical monuments

Scanning Electrochemical Cell Microscopy: A Powerful Method to Study the Intergranular Corrosions of Archaeological Silver Artifacts

Recent progress in instrumental techniques for architectural heritage materials

Advanced mapping of inorganic treatments on porous carbonate stones by combined synchrotron radiation high lateral μXRPD and μXRF

Salt Weathering of Natural Stone: A Review of Comparative Laboratory Studies

Emerging photonic technologies for cultural heritage studies: the examples of non-linear optical microscopy and photoacoustic imaging

Study of corrosion in archaeological gilded irons by Raman imaging and a coupled scanning electron microscope-Raman system

Non-Linear Microscopy: A Well-Established Technique for Biological Applications towards Serving as a Diagnostic Tool for in situ Cultural Heritage Studies

In situ DRIFT, Raman, and XRF implementation in a multianalytical methodology to diagnose the impact suffered by built heritage in urban atmospheres

Migration, Crystallization and Dissolution Changes of Salt Solution with Color Rendering Property in Porous Quartz Materials

New approach of a transient ICP-MS measurement method for samples with high salinity

A Non-Invasive In Situ Spectroscopic Analysis of Cinnabar Minerals to Assist Provenance Studies of Archaeological Pigments

Source identification of sulphate forming salts on sandstones from monuments in Salamanca, Spain--a stable isotope approach

Characterization of Anisotropic Salt Weathering through Nondestructive Techniques Mapping Using a GIS Environment

Integration of Laboratory and Field Measurements on Soil and Bronze Artifacts: Facilitating Conservation Treatment and Management of Archaeological Collections

Non-Destructive and Non-Invasive Approaches for the Identification of Hydroxy Lead-Calcium Phosphate Solid Solutions ((Pb x Ca1- x)5(PO4)3OH) in Cultural Heritage Materials

Pretty in pink? Complementary strategies for analysing pink biofilms on historical buildings

Application of the analytical methods REM/EDX, AES and SNMS to a chlorine induced aluminium corrosion