Abstract:This study proposes a series–parallel inerter system with negative stiffness for the passive vibration control of an undamped single–degree–of–freedom system under base excitation. The necessary and sufficient conditions for stability of series-parallel inerter system with negative stiffness are established by Routh–Hurwitz criterion, and the stability boundary is obtained. The tuning parameters of the series-parallel inerter system with negative stiffness are determined through fixed point theory, and a comparison between the vibration mitigation performance of series-parallel inerter system with negative stiffness, series–parallel inerter system (without negative stiffness), and tuned mass damper is presented considering both harmonic excitation, transient excitation, and random (white noise) excitation. The results of this study demonstrate that under base harmonic excitation, series-parallel inerter system with negative stiffness outperforms the series–parallel inerter system and tuned mass damper in terms of suppression bandwidth and reducing the peak vibration amplitude of the primary mass. In the case of base acceleration–excited primary structure, more than 49.84% and 67.53% improvement can be obtained from series-parallel inerter system with negative stiffness as compared with tuned mass damper in terms of suppression bandwidth and reducing the peak vibration amplitude, respectively. Whereas in the case of base displacement–excited primary structure, more than 78% and 80% improvement can be obtained from series-parallel inerter system with negative stiffness, respectively, following the same criteria. A slightly lower improvement has been obtained from series-parallel inerter system with negative stiffness as compared with series–parallel inerter system, which justified the superiority of series–parallel inerter system compared to tuned mass damper. The transient response investigation showed that series-parallel inerter system with negative stiffness outperforms the series–parallel inerter system and tuned mass damper in terms of much shorter stabilization times and lower peak amplitude of the primary mass. Finally, the further comparison among these devices (series-parallel inerter system with negative stiffness, series–parallel inerter system, and tuned mass damper) under white noise excitation also shows that series-parallel inerter system with negative stiffness is superior to series–parallel inerter system and tuned mass damper for a small inertance mass ratio. This result could provide a theoretical basis for the design of inerter-based isolators with negative stiffness.

Parameters optimization of series–parallel inerter system with negative stiffness in controlling a single–degree–of–freedom system under base excitation

Performance Analysis of High-Static-low-dynamic Stiffness Vibration Isolator with Time-Delayed Displacement Feedback

Modeling and Analysis of a High-Static-low-dynamic Stiffness Vibration Isolator with Experimental Investigation

Force and displacement transmissibility of a quasi-zero stiffness vibration isolator with geometric nonlinear damping

Effect of Negative Stiffness Mechanism in a Vibration Isolator with Asymmetric and High-Static-low-dynamic Stiffness

Resonance and Performance Analysis of a Harmonically Forced Quasi-Zero-Stiffness Vibration Isolator Considering the Effect of Mistuned Mass

On the Analysis of A Piecewise Nonlinear-Linear Vibration Isolator with High-Static-Low-Dynamic-Stiffness under Base Excitation

Minimization of the Beam Response Using Inerter-Based Passive Vibration Control Configurations

Comparison of the Dynamic Performance of Nonlinear One and Two Degree-Of-Freedom Vibration Isolators with Quasi-Zero Stiffness

Optimal Parameters for Dynamic Vibration Absorber with Negative Stiffness in Controlling Force Transmission to a Rigid Foundation

Analytical optimal design and performance evaluation of series tuned inerter damper for ground motion excited structures

Optimum design and performance evaluation of the tuned inerter-negative-stiffness damper for seismic protection of single-degree-of-freedom structures

Mechanical mechanism and parameter optimization of a tuned inerter damper with delayed fractional-order PID

Design and Analysis of a Vibration Isolator with Adjustable High Static–Low Dynamic Stiffness

A Comparative Study of Vibration Isolation Performance Using Negative Stiffness and Inerter Dampers.

Optimum design and performance of a base-isolated structure with tuned mass negative stiffness inerter damper

Parameter optimization of vibration control system for adjacent building structures based on negative stiffness inerter damper

Analytical study on the effects of flexural rigidity and negative stiffness in the optimal tuning of inerter-based damper for cable vibration mitigation

Low-frequency vibration isolation via new wide range zero-stiffness isolator with multiple negative stiffness mechanisms

Study on response mechanism of nonlinear energy sink with inerter and grounded stiffness

Semi-active control of the electromagnetic negative stiffness mechanism in a double-layer vibration isolator