Abstract:Water contamination by copper ions (Cu2+) and sulfide anions (S2-) has been a longstanding human health hazard. The limitations of current detection strategies have created a high demand for effectively monitoring the concentrations of these ions in water systems. A facile fluorescent bioassay for Cu2+ and S2- was developed in this study based on "on-off-on" fluorescent nitrogen-doped carbon dots (N-CDs). N-CDs were synthesized for the first time via thermal treatment using hexamethylene-tetramine and ammonium citrate precursors. The obtained CDs were highly stable in aqueous solution, with a strong green emission and a 51.2% quantum yield. The maximum fluorescence emission peak was observed at 478 nm for a 360-nm excitation. Notably, the fluorescence intensity of N-CDs can be quenched by a factor of 6 by Cu2+, which can be applied to Cu2+ assays ranging from 0.05 to 5 μM with a limit of detection (LOD) of 25 nM. Interestingly, further addition of S2- recovered the fluorescence of the 2+ nanocomplex, which can be used to quantify S2- in a broad range from 0.05 to 10 μM with an LOD of 32 nM. The N-CD and 2+ nanocomplexes were also demonstrated to be highly specific towards Cu2+ and S2-, respectively. Finally, the sensor was successfully applied to lake water for detecting both Cu2+ and S2-, demonstrating excellent application prospects for analytical chemistry and environmental remediation.

A Bright Nitrogen-doped-Carbon-Dots based Fluorescent Biosensor for Selective Detection of Copper Ions

The fluorescent and colorimetric dual-response sensor based on carbon dots doped with nitrogen and sulfur for detecting copper ions

Selective detection of copper ion in complex real samples based on nitrogen-doped carbon quantum dots

Carbon dots fabricated by solid-phase carbonization using p-toluidine and l-cysteine for sensitive detection of copper

Rationally Designed Efficient Dual-Mode Colorimetric/Fluorescence Sensor Based on Carbon Dots for Detection of Ph and Cu2+ Ions

Red Emitting Nitrogen-Doped Carbon Dots for Fluorescence and Colorimetric Dual-Mode Detection of Cu 2+ and Biological Sensing

N-doped carbon dots for highly sensitive and selective sensing of copper ion and sulfide anion in lake water

Functional ZnS:Mn(II) quantum dot modified with L-cysteine and 6-mercaptonicotinic acid as a fluorometric probe for copper(II)

Ionophore-based nanospheres enable selective and sensitive fluorescence detection of copper ions

Highly Sensitive and Selective Determination of Copper(ii) Based on a Dual Catalytic Effect and by Using Silicon Nanoparticles As a Fluorescent Probe.

Ultrasensitive and Highly Selective Detection of Cu2+ Ions Based on a New Carbazole-Schiff

A ratiometric fluorescent probe based on PCN-224 for rapid and ultrasensitive detection of copper ions

Synthesis of Up-Conversion Fluorescence N-Doped Carbon Dots with High Selectivity and Sensitivity for Detection of Cu2+ Ions

Fluorescent and colorimetric dual-mode detection of Cu2+ based on carbon dots

Colorimetric and Fluorescent Sensing of Copper Ions in Water through o-Phenylenediamine-Derived Carbon Dots

Novel Fluorescent Chemosensor Sensitively Detect Copper (II) Through the Collaboration of Quinoline and Coumarin Groups

Sustainable route for synthesis of nitrogen-doped carbon dots with high efficiency for iron(III) and copper(II) ions detection

Preparation of high quantum yield nitrogen and sulfur co-doped carbon dots for sensitive detection of Cu2+

Visual Determination of Copper (II) Using a Biomass Sourced Carbon Quantum Dot (CQD) Ratiometric Fluorescent Probe

Functionalized Green Carbon dots for Specific Detection of Copper in Human Serum Samples and Living Cells

Fluorescent detection of Cu (II) ions based on DNAzymatic cascaded cyclic amplification