Abstract:Wearable thermoelectric generators (w-TEGs) convert thermal energy into electrical energy to realize self-powering of intelligent electronic devices, thus reducing the burden of battery replacement and charging, and improving the usage time and efficiency of electronic devices. Through finite element simulation, this study successfully designed high-performance thermoelectric generator and made it into wearable thermoelectric module by adopting “rigid device—flexible connection” method. It was found that higher convective heat transfer coefficient (h) on cold-end leads to larger effective temperature difference (ΔTeff) and better power generation performance of device in typical wearable scenario. Meanwhile, at same h on the cold-end, longer TE leg length leads to larger ΔTeff established at both ends of device, larger device output power (Pout) and open-circuit voltage (Uoc). However, when the h increases to a certain level, optimization effect of increasing TE leg length on device power generation performance will gradually diminish. For devices with fixed temperature difference between two ends, longer TE leg length leads to higher resistance of TEGs, resulting in lower device Pout but slight increase in Uoc. Finally, sixteen 16 × 4 × 2 mm2 TEGs (L = 1.38 mm, W = 0.6 mm) and two modules were fabricated and tested. At hot end temperature Th = 33 °C and cold end temperature Tc = 30 °C, the actual maximum Pout of the TEG was about 0.2 mW, and the actual maximum Pout of the TEG module was about 1.602 mW, which is highly consistent with the simulated value. This work brings great convenience to research and development of wearable thermoelectric modules and provides new, environmentally friendly and efficient power solution for wearable devices.

Author Correction: High-performance compliant thermoelectric generators with magnetically self-assembled soft heat conductors for self-powered wearable electronics

Persistently Self-Powered Wearable Thermoelectric Generator Enabled by Phase-Change Inorganics As the Heat Sink

Correction: Computer-aided Design of High-Efficiency GeTe-based Thermoelectric Devices

Comprehensive Performance Prediction and Power Promotion for Wearable Thermoelectric Generator with Flexible Encapsulation in Practical Application

Correction: Li, S. Et Al. Research on a Power Management System for Thermoelectric Generators to Drive Wireless Sensors on a Spindle Unit. Sensors 2014, 14, 12701–12714

Correction: Corrigendum: Superparamagnetic enhancement of thermoelectric performance

Comfortable wearable thermoelectric generator with high output power

Passive Radiative Cooling Enables Improved Performance in Wearable Thermoelectric Generators

Publisher Correction: An electrically conductive silver–polyacrylamide–alginate hydrogel composite for soft electronics

Publisher Correction: an Electrochemical Thermal Transistor

Correction: Three-dimensional Hybridized Carbon Networks for High Performance Thermoelectric Applications

High-Performance Wearable Bi2Te3-Based Thermoelectric Generator

Partially Air‐Filled Skin‐Attachable Deformable Gasket with Negative Poisson's Ratio for Highly‐Efficient Stretchable Thermoelectric Generators (Adv. Energy Mater. 40/2023)

Ionic Thermoelectric Paper

Energy Conversion Performance Optimization and Strength Evaluation of a Wearable Thermoelectric Generator Made of a Thermoelectric Layer on a Flexible Substrate

Correction: Molecular-scale Thermoelectricity: As Simple As ‘ABC’

Optimization Design and Performance Study of Wearable Thermoelectric Device Using Phase Change Material as Heat Sink

High-Performance, Wearable Thermoelectric Generator Based on a Highly Aligned Carbon Nanotube Sheet

Correction: Ultrahigh power factor and flexible silver selenide-based composite film for thermoelectric devices

Defect-engineered Reduced Graphene Oxide Sheets with High Electric Conductivity and Controlled Thermal Conductivity for Soft and Flexible Wearable Thermoelectric Generators