A Voltage Balancing Method for Series-Connected Power Devices Based on Active Clamping in Voltage Source Converters

Zhi Gao,Shuai Shao,Wentao Cui,Junming Zhang,Xiangrong Chen,Kuang Sheng

DOI: https://doi.org/10.1109/tpel.2022.3163586

IF: 5.967

2022-01-01

IEEE Transactions on Power Electronics

Abstract:This article proposes a voltage balancing technique for series-connected power devices in voltage source converters (VSCs). Each main power device has an active clamping module (ACM), consisting of a capacitor and an auxiliary switch. The ACM can clamp the main power device voltage, and voltage sharing among series-connected power devices can be realized by balancing the ACM capacitor voltages. The balancing circuit does not affect the normal operation of the devices and the introduced power losses can be ignored. The possible charging and discharging principles of the ACM capacitors are summarized. Then, the control strategy to balance the ACM capacitor voltages is introduced. The operating principles of a VSC with series-connected devices and the proposed balancing circuits are presented, including charging stage, discharging stage, and steady voltage stage. A switching sequence of auxiliary switch and main power switch is proposed to ensure ZVS-on of the auxiliary switch. Besides, design considerations of key parameters are presented. Finally, experimental results are provided to verify the effectiveness and feasibility of the proposed method. The voltage imbalance degree of the six series-connected devices is less than 3% under different operating conditions. The proposed method shows good balancing performance, good scalability, and low power losses.

engineering, electrical & electronic