Abstract:To obtain the mechanical properties of greenhouse cucumber cane, tensile and shear properties of the greenhouse cucumber cane were studied by using computer-controlled electronic universal testing machine and homemade cutting test bench, respectively. Firstly, the root, middle and head of cucumber cane were subjected for tensile tests. The tensile stress-strain curves showed that the root of cumber cane presented the characteristics of plastic material, while the middle and head showed the characteristics of brittle material. The average tensile strength of root, middle and head of fresh cucumber cane were 7.35 MPa, 6.30 MPa and 4.68 MPa, respectively. The average elastic modulus of root of fresh cucumber cane was 280.58 MPa, which was much greater than the middle and head with average elastic modulus of 198.81 MPa and 137.22 MPa, respectively. A pendulum impact cutting test-rig and a cutting force measurement system composed of a cantilever weigh sensor, a high frequency DAQ card and motion control card were developed. The cutting mechanical property experiments of different parts of greenhouse cucumber cane were carried out, and the continuous curves of cutting force were measured. The single factor test for cross-sectional area, cutting speed, cutting tool type and manner were analyzed. The results indicated that the peak cutting force increased approximately linearly with the increasing of cutting sectional area, but decreased gradually with the increasing of cutting speed. In the same conditions, the cutting force could be reduced by using straight blade cutting tool and ramp cutting way. Through the multifactor interaction impact test of the cutting way, the blade type and the cutting speed, it was found that the corresponding F-value of the three factors were 21.316, 49.141 and 0.222, which suggests that the blade type is the most significant factor for the cutting force.

Study on the Compressive Elastic Modulus and Poisson’s Ratio of Tobacco Main Veins

Experimental study on connection strength between tobacco stem and leaf

Study of Sampling Conditions on the Elastic Modulus of Corn Straw

Discrete element modeling and experimental study of biomechanical properties of cotton stalks in machine-harvested film-stalk mixtures

Mechanical Properties Measurement and Statistical Analysis of Paddy Stem Based on Image Analysis Method

Investigation of the Three-Dimensional Micromechanical Behavior of Woven-Fabric Composites

Elastic Modulus Prediction of Filament Winding Composites Based on Micromechanical Model

Prediction of Tobacco Leaves Strips Yield and Its Relationship with Other Physical Characteristics

Experiment and analysis of physical, mechanical, and viscoelastic properties of the roots and stalks of green leafy vegetables

Study on the Relation Ship Between Thermal Conductivity and Water Content of Tobacco Stack

Study on the Variation Law of the Main Mechanical Properties in the Processing of Longjing Tea

Study on Viscoelastic Poisson's Ratio of Nonwovens

Tensile Mechanical Properties of Greenhouse Cucumber Cane

Research on the automatic modeling and performance prediction of plain-woven composites based on beam elements

Experimental study on tensile properties of corn straw

An Analytical Model For Predicting The Tension Modulus And Poisson'S Ratio Of Satin Weave Composites

Relationship between Mechanical Property and Contents of Nitrogen, Phosphorus and Potassium of Wheat Stem

Report on Soil Compaction Stress Affecting Tobacco Early Growth

Construction of constitutive model and parameter determination of green Sichuan pepper (Zanthoxylum armatum) branches

MECHANICAL MODEL OF CERASUS HUMILIS ESTABLISHED BY UNIAXIAL COMPRESSION PHYSICAL TEST AND VIRTUAL SIMULATION

Effect of Press on Reconstituted Tobacco Paper-base Properties