Abstract:This article presents the research on a road lighting design. In this kind of design for a specific type of a roadway, the number and spacing of luminaires are calculated on the basis of luminaire photometric parameters such as intensity curve (LPIC) and luminous flux. The values of these parameters are measured using the luxmeter, i.e., a measuring instrument in which the spectral sensitivity should imitate spectral sensitivity of the human eye V(λ). However, the luxmeter’s spectral sensitivity S(λ) is not perfectly matched with the required one and varies for different instruments, resulting in measurement errors. To avoid this measurement error, the spectral mismatch correction factor (SMCF) should be applied to luxmeter’s readings. For a given luxmeter, the SMCF values depend on the measured light’s spectral composition SPD (described also by the lamp’s correlated color temperature CCT). Unfortunately, many laboratories do not apply SMCF to their luxmeter readings. Typical measurement laboratories are not in possession of SMCF data as this kind of data is hard to obtain and can be provided only by the state-of-the-art photometric laboratories for a high cost. Consequently, these typical measurement laboratories provide inaccurate LPIC data to costumers. In this article, it has been shown that a design process of road lighting installations needs to be based on lighting fixture LPIC’s measurements with SMCF values being taken into account. Omitting this fact may result in road lighting installation made on the basis of a design utilizing incorrect LPIC data, which would have higher energy consumption then expected at a design stage.

An Approach To Comparative Simulation Of Road Lighting and Estimation Of Associated Quality Parameters

Experimental Research On Distribution Of Led'S Light Intensity

A Typical Light Distribution Design In The High Efficient Led Street Lamp

Conceptual Design of Dedicated Road Lighting for City Park and Housing Estate

A Novel Optimization Strategy For Led Street Lamp Designing

Optimal Selection of Distribution, Power, and Type of Luminaires for Street Lighting Designs Using Multi-Criteria Decision Model

Quantitative comparison of photometric quantities for road lighting between CIE and IESNA standards

Comparative Study on Simulation Softwares of Natural Light Environment

Surrounding Ratio Analysis for Urban Road Lighting Based on MATLAB

The Influence of Luminaire Photometric Intensity Curve Measurements Quality on Road Lighting Design Parameters

The Optical Design of a LED-Reflector Module in Road Illumination

Comparison Research of Street Lamps: Characteristic Parameters and Lighting Performance of Light-Emitting Diodes, High Pressure Sodium Lamps and Ceramic Discharge Metal Halide Lamps

Comparative study on simulation performances of CORSIM and VISSIM for urban street network.

Influence of Pavement Heterogeneity and Observation Angle on Lighting Design: Study with New Metrics

Comparing The Quality Of The Led Based And Conventional Cie Illuminant Simulators

Optimal design of light distribution of LED luminaries for road lighting

The Application of Performance Based Method in Road Lighting

An educational approach to a lighting design simulation using DIALux evo software

Experimental Verification of Performance Method for Vehicle Headlighting Systems in China

Parametric Regression Model for Lighting Calibration

Design of Freeform Lens for Optimazation of Luminous Intensity Distribution Based on Luminance Coefficient