Abstract:Parameter values adopted in railway engineering analysis at present are generally obtained through triaxial tests, whereas the remarkable difference between the actual stress path during train passage and the loading path in cyclic triaxial tests may lead to inaccurate predictions and even engineering problems. Published researches show that the actual stress path probably contains principal stress rotation(PSR), which has a sisgnificant influence on the mechanical response of soil. However, the conventional approach, i.e. cyclic triaxial test is not efficient in simulating this complicated stress path involving PSR. Instead, hollow cylinder test with cyclic shear stress has been proved to be an excellent selection for PSR study. In order to obtain reliable stress path for guiding hollow cylinder tests, three-dimensional calculation for a certain urban railway is carried out; and the distribution regularity of cyclic stress amplitudes, cycle numbers and PSR under train loads is analyzed. Furthermore, a series of cyclic torsional shear tests on hollow cylinder samples is employed to simulate the complex stress path and to research the deformation and pore pressure accumulation properties of saturated soft clay. Considering stress in foundation soil decreasing along with the depth increasing, various cyclic stress amplitudes corresponding to different depths are adopted in this experiment study. Three-dimensional calculation shows that the major principal stress axis will rotate from -90 degrees to 90 degrees during the train loading passage as well as the number and amplitude of stress waves reduce gradually with the increase of depth. It is also shown that both PSR and stress are quite sensitive to train loads as the upper soil element can identify a single wheel load while the lower soil element can just identify a bogie and even the whole train load. And through the cyclic torsional shear tests, it's obvious that the rotation of principal stress can promote the accumulation of pore pressure and strain in soft soil foundations significantly; and in the case when vertical cyclic stress amplitude equals to 15 kPa, the pore pressure and strain in cyclic torsional shear test are 77% and nearly 50% higher than that in cyclic triaxial test respectively. What's more, as the cyclic stress amplitude increases, the gap of cumulative pore pressure and strain between that two types of tests will enlarge further, which may even result in essential difference that samples in triaxial tests show only small strain whereas failure in torsional shear tests.

Shakedown response of recycled rubber-granular waste mixtures under cyclic loading

Cyclic and Postcyclic Triaxial Testing of Ballast and Subballast

Track settlement restoration of ballastless high-speed railway using polyurethane grouting: Full-scale model testing

Shakedown of unbound granular material

Constitutive behaviour of a granular matrix containing coal mine waste intermixed with rubber crumbs

High-Cycle Computational Model for Accumulative Deformation of Granular Material under Repeated Traffic Loading

Role of elastic upper limit in shakedown study for granular soils

High-cycle Shakedown, Ratcheting and Liquefaction Behavior of Anisotropic Granular Material with Fabric Evolution: Experiments and Constitutive Modelling

Experimental Investigation into the Shakedown State of Unsaturated Road Base Aggregate at Various Fine Contents and Matric Suctions

Influence of Grain Gradation on Permanent Strain of Unbound Granular Materials under Low Confining Pressure and High-Cycle Loading

Influence of shear yield strength of rail material on the shakedown limit in shakedown map

Evaluation of Critical Dynamic Stress and Accumulative Plastic Strain of an Unbound Granular Material Based on Cyclic Triaxial Tests

Long Term Cyclic Behavior of Unsaturated Granular Soils

Research on mechanical response of soft clay under cyclic loading involving principal stress rotation

Undrained deformation behavior of saturated soft clay under long-term cyclic loading

Development of elasto-plastic constitutive model for unbound granular materials under repeated loads

A New Approach for Classifying the Permanent Deformation Properties of Granular Materials under Cyclic Loading

Experimental study on dynamic characteristics of unbound granular materials under cyclic loading with different frequencies

Subgrade soil response to rail loading: Instability mechanisms, causative factors, and preventive measures

Use of Geogrids and Recycled Rubber in Railroad Infrastructure for Enhanced Performance

Experimental Investigation on the Behavior of Gravelly Sand Reinforced with Geogrid under Cyclic Loading