Abstract:Capricious digital filter (CDF) plays a significant role of signal processing application field to eradicate noise. Any prototype filter desired frequency response is attained by developing all pass makeover-based capricious digital filter (APM-CDF) that sustains full control on cutoff frequency. The benefits of APM-CDF are limited through its speed, area, and power consume. In this manuscript, Baugh–Wooley multiplier (BWM) with error reduced carry prediction approximate adder (ERCPAA) is proposed to accelerate the filter design, decreasing the area and power consume. ERCPAA is a rapid binary adder that takes low power and area. ERCPAA adder is separated as 3 blocks: approximate full adder cells, carry prediction logic, constant truncation including error diminishing logic, these reduce power with area. BWM is utilized to decrease the hardware complex including high speed, lesser area, and lesser power consume. The proposed filter is applicable in ECG signal noise removing applications to offer filtered higher-quality signals. The proposed filter is implemented in Verilog and simulation is activated in Xilinx ISE 14.5 tool. The simulation outcomes shows lesser delay 32.87%, 26.88%, and 32.88%, and lower area 20%, 80%, and 65% comparing to the existing filters, like partial product adding in Vedic design-ripple carry adder model FIR filter for electrocardiogram signal denoising algorithm (DF-4VM-CSA), Vedic design-carry look ahead (VMD-CLA), respectively. The proposed filter is activated in MATLAB/Simulink for reading input ECG signal. Finally, the proposed filter attains 34.86%, 26.98% higher SNR analyzed to the existing filters, like DF-4VM-CSA, DF-VMD-CLA, respectively.

DESIGN OF FIR FILTER ALGORITHM FOR NOISE REMOVAL IN ECG SIGNAL USING OPEN CORE SoC

Reconfigurable Architectures with High-Frequency Noise Suppression for Wearable ECG Devices

Open Cores for Digital Signal Processing

A novel low-complexity digital filter design for wearable ECG devices

Design and Implementation of Multiplierless FIR Filter Using COOT Bird Optimization Algorithm with Different Architectures*

Power and area efficient FIR filter using Radix- 2r multiplier for de-noise the electrooculography (EOG) signal

Low Area and Power-Efficient FPGA Implementation of Improved AM-CSA-IIR Filter Design for the DSP Application

The Design and Implementation of Fir Filter Based on Improved Da Algorithm

Design and Implementation of Hybrid Techniques and DA-based Reconfigurable FIR Filter Design for Noise Removal in EEG Signals on FPGA

Design and implementation of a multiband digital filter using FPGA to extract the ECG signal in the presence of different interference signals

VLSI implementation of booth multiplier and carry select adder based fir filter design for ECG signal denoising

Higher order and optimized symmetric 2D FIR filter design and hardware architecture implementation using CSD-CSE

An efficient reconfigurable FIR filter design with coefficient optimization using a modified bacterial foraging optimization algorithm

Capricious Digital Filter Design and Implementation Using Baugh–Wooley Multiplier and Error Reduced Carry Prediction Approximate Adder for ECG Noise Removal Application

Design and FPGA Implementation of an Efficient Architecture for Noise Removal in ECG Signals Using Lifting-Based Wavelet Denoising

In-filter Computing For Designing Ultra-light Acoustic Pattern Recognizers

Optimised Design and Implementation of Band-Pass Filter for Neural Recording System

Design and implementation of optimized 2D FIR symmetric filter architecture using modified McClellan transformation and CSD-CSE

Adaptive FIR Filter Design with Approximate Adder and Hybridized Multiplier for Efficient Noise Eradication in Sensor Nodes

Modeling and simulation of FIR filter using distributed arithmetic algorithm on FPGA

Design and Fpga Implementation of High-Speed Square-Root-Raised-Cosine Fir Filters