Abstract:Damping is an important factor contributing to errors in the measurement of rotational inertia using the torsion pendulum method. Identifying the system damping allows for minimizing the measurement errors of rotational inertia, and accurate continuous sampling of torsional vibration angular displacement is the key to realizing system damping identification. To address this issue, this paper proposes a novel method for measuring the rotational inertia of rigid bodies based on monocular vision and the torsion pendulum method. In this study, a mathematical model of torsional oscillation under a linear damping condition is established, and an analytical relationship between the damping coefficient, torsional period, and measured rotational inertia is obtained. A high-speed industrial camera is used to continuously photograph the markers on a torsion vibration motion test bench. After several data processing steps, including image preprocessing, edge detection, and feature extraction, with the aid of a geometric model of the imaging system, the angular displacement of each frame of the image corresponding to the torsion vibration motion is calculated. From the characteristic points on the angular displacement curve, the period and amplitude modulation parameters of the torsion vibration motion can be obtained, and finally the rotational inertia of the load can be derived. The experimental results demonstrate that the proposed method and system described in this paper can achieve accurate measurements of the rotational inertia of objects. Within the range of 0–100 × 10−3 kg·m2, the standard deviation of the measurements is better than 0.90 × 10−4 kg·m2, and the absolute value of the measurement error is less than 2.00 × 10−4 kg·m2. Compared to conventional torsion pendulum methods, the proposed method effectively identifies damping using machine vision, thereby significantly reducing measurement errors caused by damping. The system has a simple structure, low cost, and promising prospects for practical applications.

Measurement of the yaw moment of inertia of a go-kart

A Novel Moment of Inertia Identification Strategy for Permanent Magnet Motor System Based on Integral Chain Differentiator and Kalman Filter

Models of Two-Axle Driving Vehicle Used for Dynamometer Test Bench

A New Method for Rotor Inertia Measurement Base on Motor Free Retardation

Modeling and field-experiments identification of vertical dynamics of vehicle with active anti-roll bar

IMPROVEMENT OF EXPERIMENTAL IDENTIFICATION METHOD WITH TRIFILAR TORSIONAL PENDULUM FOR INERTIA PROPERTIES OF LARGE-SCALE RIGID-BODY

Research on Yaw Moment Control System for Race Cars Using Drive and Brake Torques

On the model-based design of front-to-total anti-roll moment distribution controllers for yaw rate tracking

Research on the Measurement Technology of Rotational Inertia of Rigid Body Based on the Principles of Monocular Vision and Torsion Pendulum

Design of Rotational Inertia Measure-Meter for Great Missile

Robust Yaw-Moment Control For Electric Vehicles

A study on structural behaviour and vibrational characteristics of a go-kart chassis

Comparison of Two Experiments Based on a Physical and a Torsion Pendulum to Determine the Mass Moment of Inertia Including Measurement Uncertainties

Yaw Moment Observer Design for Electric Vehicles Considering Vehicle Speed Variation

Estimating the internal friction and the rotationalinertia of a homemade oscillatory system

A Method for Measuring the Inertia Properties of a Rigid Body Using 3-URU Parallel Mechanism

Yaw Moment Control for Skid Steered Vehicle with Distributed Motor Drive

Robust Yaw Stability Control for In-Wheel Motor Electric Vehicles

Numerical and Experimental Modal Analysis of Go Kart Chassis

Development of a total variance handling dynamics evaluation index for three-axle coach based on residue theorem

Research on Measuring Methods for Aircraft's Moment of Inertia based on Composite Torsion Pendulum Movement