Abstract:This paper presents fabrication of an ultrasonic regenerative evaporative cooler, coupled with a desiccant dehumidifier. Ultrasonic regenerative evaporative cooler consists of several sets of a dry channel and a wet channel. A part of the air from the dry channel is redirected into the wet channel where it is cooled by evaporation of water mist from an ultrasonic atomiser. Air flowing through dry channels is pre-cooled by heat transfer between wet and dry channels, without changing its humidity. In this cooler, the conventional hygroscopic layer for wetting the plate surface is replaced with the water mist. It is observed that the performance of the cooling system significantly depends on the channel spacing, channel length, inlet airflow rate and extraction ratio, and marginally depends upon feed water temperature. The room cooling capacity is eminently responsive to both air mass flow rate and extraction ratio. The maximum available room cooling capacity of 339.8 W is obtained for the optimal values of 0.0488 kg/s mass flow rate of air and 0.37 extraction ratio. The prototype achieved wet-bulb effectiveness values as high as 1.15 and delivered more than 10°C temperature drop. Practical application: An ultrasonic regenerative evaporative cooler can be coupled with a desiccant dehumidification unit for use in hot and humid climate to achieve comfort condition utilising less energy and feed water when compared to the vapour compression refrigeration system. From this prototype researchers and engineers can develop, by combining desiccant regenerators and evaporative coolers which use ultrasonic method for low-temperature dehydration of desiccant substance. Solar thermal energy can also be directly utilised for marginally heating the desiccant substance during the regeneration process. Overall, this system can contribute to the development of energy efficient buildings.

Developments in liquid desiccant dehumidification system integrated with evaporative cooling technology

Analysis of a Hybrid System of Adiabatic Absorption two-stage Liquid Desiccant and CO2 Transcritical Cycles

Optimization of the Liquid Desiccant Cooling Systems in Hot and Humid Areas

Liquid Desiccants Applications in Cooling and Dehumidification – An Overview

Experimental study of an ultrasonic regenerative evaporative cooler for a desiccant cooling system

Evaporative Cooling Integrated with Solid Desiccant Systems: A Review

Liquid Desiccant Air Conditioning Using Single Storage Solution Tank, Evaporative Cooling, and Marquise-Shaped Solar Collector

Research Progress in Liquid Desiccant Air-Conditioning Devices and Systems

An Introduction Of Independent Humidity Control System With Liquid Desiccant Air Conditioner

Experimental Performance Investigation on a Desiccant-Assisted Two-Stage Evaporative Cooling System in Hot and Humid Areas

Response surface modeling and optimization scheme of an internally cooled liquid desiccant air conditioning system

An Introduction to Solid Desiccant Cooling Technology

System and performance of liquid desiccant air conditioner

Desiccant cooling as an alternative to traditional air conditioners in green cooling technology

Performance and design analyses of various configurations of dew point evaporative cooling-based desiccant air-conditioning (DAC) systems for hot and humid conditions

A vision of dew point evaporative cooling: Opportunities and challenges

Investigation of a Compact Hybrid Liquid-Desiccant Air-Conditioning System for Return Air Dehumidification

Development of Solid Desiccant Dehumidification Using Electro-Osmosis Regeneration Method for HVAC Application

Experimental and Numerical Investigation of a Novel Hybrid Deep-Dehumidification System Using Liquid Desiccant

Review of Internally Cooled Liquid Desiccant Air Dehumidification: Materials, Components, Systems, and Performances

Design of heat pump-driven liquid desiccant air conditioning systems for residential building