Abstract:Piezoelectric energy harvesting from roadways, which converts ambient vibration energy of roads into electric energy, has a wide range of potential applications in intelligent transportation systems. On-site open-traffic tests revealed that energy harvested by piezoelectric energy harvester (PEH) units embedded in roadways is far less than the value in laboratories, which may be because the parameters of traffic flow load (frequency, distribution, wave shape, etc.) and the road structure are significantly different from the pre-established conditions in laboratories or even on-site tests with only one vehicle passing. To address this issue, an analytical model for piezoelectric energy harvesting from roadways under open-traffic conditions was proposed to examine the mechanical response of the road structure and the electrical performance of the stack PEH units embedded in the road. The influence of all parameters in the energy-harvesting system was then obtained with the scaling law method, revealing that the energy harvested by PEH units is determined by the energy coefficient, the system's intrinsic parameter, normalized parameters of roadways, and the normalized embedded position of PEH units. It is found that that the energy-harvesting system's intrinsic parameter should be approximately 0.8 to ensure maximum energy-harvesting efficiency. Meanwhile, the pavement with lower bending stiffness and higher linear density while the foundation with small stiffness and smaller damping coefficient would be more suitable for energy harvesting. Furthermore, the lateral embedded position of PEH units should be carefully chosen, since the units embedded in an optimal position can harvest three times more than that embedded in other positions. The concise criteria presented in this study will be used as a reference not only for material selection, dimension optimization, and embedded positions determination of PEH units but also for choosing of the optimal roadways to achieve maximum piezoelectric energy harvesting efficiency under open-traffic conditions.

Multi-physics modelling of piezoelectric pavement system for energy harvesting under traffic loading

The Optimal Design of a Piezoelectric Energy Harvester for Smart Pavements

Theoretical Assessment on Piezoelectric Energy Harvesting in Smart Self-powered Asphalt Pavements

Optimal Lateral Embedded Position of Piezoelectric Energy Harvesters under Various Traffic Conditions with Wheel-Path Distribution

Piezoelectric Energy Harvesting from Roadways under Open-Traffic Conditions: Analysis and Optimization with Scaling Law Method

Mechanical Energy Harvesting from Road Pavements under Vehicular Load Using Embedded Piezoelectric Elements

Piezoelectric Energy Harvesting from Roadway Deformation under Various Traffic Flow Conditions

Coupled dynamic and piezoelectric response of RPEHs embedded in road under traffic load via multiscale finite element models

Numerical Study on Influence of Piezoelectric Energy Harvester on Asphalt Pavement Structural Responses

Development of a Pavement-Embedded Piezoelectric Harvester in a Real Traffic Environment

Performance Analysis of Piezoelectric Energy Harvesting in Pavement: Laboratory Testing and Field Simulation

Numerical Analysis of Signal Response Characteristic of Piezoelectric Energy Harvesters Embedded in Pavement

Low-Cost Novel Piezoelectric Module for Harvesting Energy from Two-Layer Pavement Systems

Development in Stacked-Array-Type Piezoelectric Energy Harvester in Asphalt Pavement

Experimental Investigation of Piezoelectric Energy Harvesters Applied in Concrete Pavement

Design of piezoelectric device compatible with pavement considering traffic: Simulation, laboratory and on-site

Finite Element Modeling and Performance Evaluation of Piezoelectric Energy Harvesters with Various Piezoelectric Unit Distributions

Piezoelectric Energy Harvesting From Roadways Based on Pavement Compatible Package

Performance Assessment and Comparison of Two Piezoelectric Energy Harvesters Developed for Pavement Application: Case Study

Development of Piezoelectric Energy Harvester System through Optimizing Multiple Structural Parameters

Electric energy output model of a piezoelectric transducer for pavement application under vehicle load excitation