Abstract:Phase sensitive optical time domain reflectometry (Φ-OTDR) has been widely used in many applications for its distributed sensing ability on weak disturbance all along the sensing fiber. However, traditional Φ-OTDR cannot make quantitative measurement on the external disturbance due to the randomly distributed position and reflectivity of scatters within the optical fiber. Recently, some methods have been proposed to realize quantitative measurement of dynamic strain. In these literatures, the fiber with or without FBGs in practice was easily damaged and with difficulty of maintenance. PZT is employed to generate strain event in the fiber. There is a large gap compared with the real detecting environment, which will not reveal the full performance of the sensing system. In this paper, a distributed optical fiber sensing (DOFS) system for dynamic strain measurement based on artificial reflector is proposed and demonstrated experimentally. The fiber under test (FUT) is composed by four 20-meter long single mode optical fiber patch cords (OFPCs), which are cascaded with ferrule contactor/physical contact (FC/PC) connectors via fiber flanges. The fiber facet of FC/PC connector forms an artificial reflector. When the interval between the two reflectors is changed, the phase of the interference signal will also be changed. A symmetric 3×3 coupler with table-look-up scheme is introduced to discriminate the phase change through interference intensity. In our experiment, the center 10m section of the second OFPC is attached to the bottom of an aluminum alloy plate. An ordinary loudspeaker box was located on the top of the aluminum alloy plate. The dynamic strain generated by the loudspeaker box is transmitted from the aluminum alloy plate to the OFPC. Experimental results show that the proposed method has a good frequency response characteristic up to 3.2 kHz and a linear intensity response of R2=0.9986 while the optical probe pulse width and repetition rate were 100ns and 10 kHz respectively. Meanwhile, triangle and cosine amplitude-modulated (AM) dynamic strain applied on the fiber are successfully discriminated. The artificial reflectors based on FC/PCs were easily assembled and maintained, and the method of vibration transmission closely resembled the real circumstance than PZT. Therefore, these advantages will extend the potential of this Φ-OTDR technology in structure health monitoring.

Quadrature phase shift technique for measurement of strain, optical power transmission, and length in optical fibers

Quadrature Phase-Stabilized Three-Wavelength Interrogation of a Fiber-Optic Fabry-Perot Acoustic Sensor.

Fiber Grating Sensor Using Dynamic PZT Modulation

Sub-Nano-Strain Multiplexed Fiber Optic Sensor Array for Quasi-Static Strain Measurement

Demonstration of an Optical Phase Conjugation Based Dual‐hop PDM‐QPSK Free‐space Optical Communication Link

Quantitative Phase Measurements Using Optical Quadrature Microscopy.

Quadrature phase-shift keying modulation with random coding pulse for long-range φ-OTDR

Experimental Demonstration of QPSK Optical Transmission with Optical Phase Conjugation

The phase interrogation method for optical fiber sensor by analyzing the fork interference pattern

High-speed Quasi-Distributed Strain Sensing Based on Time Division Multiplexing of Fibre Bragg Gratings

Multi-point Dynamic Strain Sensing using External Phase Modulation-based Brillouin Optical Correlation Domain Analysis

Distributed Fiber Deformation Measurement by High-Accuracy Phase Detection in OFDR Scheme

A Distributed Optical Fiber Sensing System for Dynamic Strain Measurement Based on Artificial Reflector

High-Resolution Optical Fiber Strain Sensor Array Based on Pound-Drever-Hall Technique With Fast Phase Regulation Method

8-port homodyne detection of optical fields using IQ demodulation

Fibre segment interferometry using code-division multiplexed optical signal processing for strain sensing applications

A Long-Haul and High-Accuracy Fiber Length Measurement Technology Based on Mach-Zehnder and Sagnac Hybrid Interferometer

Research of Simultaneous Measurement of Temperature and Strain of Fiber Optic Cable Material

Quasi-distributed acoustic sensing with interleaved identical chirped pulses for multiplying the measurement slew-rate

Universal Fiber-Optic Point Sensor System for Quasi-Static Absolute Measurements of Multiparameters Exploiting Low Coherence Interrogation

Coherent Pound-Drever-Hall Technique for High Resolution Fiber-Optic Strain Sensor at Very Low Light Power