Abstract:Abstract The performance of adhesive-hardwood bonds can often be sensitive to humidity and temperature variation. Therefore, it is frequently challenging to achieve standard requirements for structural applications. To gain a better understanding of the wood-adhesive bond, the properties of the individual constituents as well as the local interface of European beech ( Fagus sylvatica L.) wood cell walls in contact with structural adhesives were analyzed by means of nanoindentation. These results are compared to classical lap-shear strength. As adhesives two different one-component polyurethane adhesives (1C PUR) and a phenol resorcinol formaldehyde adhesive (PRF) were used. In one case, the beech wood was additionally pre-treated with an adhesion-promoting agent (primer) prior to bonding with 1C PUR. Beech wood joints were analyzed subsequent to several treatments, namely standard climate, after wet storage and in re-dried conditions. In addition, the influence of the primer on the hydroxyl accessibility of beech wood was investigated with dynamic vapor sorption (DVS). The lap-shear strength revealed good performance in dry and re-dried conditions for all adhesives on beech. Both polyurethane adhesives obtained deficits when tested in wet conditions. The use of a primer significantly improved the PUR performance in wet condition. DVS experiment demonstrated a decrease in hydroxyl group accessibility when using a high primer concentration. As novelty, nanoindentation was used for the first time to characterize the local wood–adhesive-interface properties in wet conditions. Nanoindentation showed that all tested 1C PUR perform quite similar in room climate, while PRF achieves considerable higher values for reduced E-modulus and hardness. Wet storage led to a considerable reduction in mechanical properties for all adhesives, while the highest relative change was observed for PRF. After re-drying, the adhesives re-gained a large part of their original mechanical properties in room climate. No distinct effect of the primer on the local micromechanical properties could be detected with nanoindentation in terms of specific work of indentation.

Selected previous findings on the factors influencing the gluing quality of solid wood products in timber construction and possible developments: A review

Green-glued engineered products from fast growing Eucalyptus trees: a review

Assessing Adhesion and Glue-Line Defects in Cold-Pressing Lamination of Glubam

Production, Environmental Impact and Mechanical Properties of Glubam

CREATING DURABLE WOOD GLUE STRUCTURES BASED ON PHYSICOMODIFIED ADHESIVES

Survey of selected adhesive bonding properties of nine European softwood and hardwood species

Assessment of the bonding quality of Australian cedar lamellas for glulam beams produced with different adhesives and surface finishes

Understanding the impact of wood type and moisture on the bonding strength of glued wood

Gluing Techniques on Bond Performance and Mechanical Properties of Cross-Laminated Timber (CLT) Made from Larix kaempferi

Engineering of material properties by adhesive selection at the example of a novel structural wood material

Characterization of wood-adhesive bonds in wet conditions by means of nanoindentation and tensile shear strength

Easy Preparation, High Water Resistance Glucose-Based Environment-Friendly Wood Adhesives

The role of wood extractives in structural hardwood bonding and their influence on different adhesive systems

Features of Gluing a Wood–Polymer Material

Results of experimental studies on the strength of adhesive-bonded joints of thermally modified ash wood

A review of factors influencing the durability of structural bonded timber joints

Investigations on the Characterization of Various Adhesive Joints by Means of Nanoindentation and Computer Tomography

A discussion on the various aspects of the minimum pressing time for polyurethane adhesives

Non-standard adhesives for wood-based composites: powder adhesives and bicomponent fibers

Research Development of Glued Laminated Bamboo (glubam) and Cross-Laminated Bamboo and Timber (CLBT)

Suitability of selected hardwood species for the production of glued laminated timberEignung ausgewählter Laubholzarten zur Herstellung von Brettschichtholz