Abstract:Two fluorescent high‐performance polymers based on dicyanoarylamine luminogens were readily synthesized via polycondensation. Both polymers were soluble in several polar aprotic solvents and exhibited useful levels of thermal stability. The polymers were emissive in both solution and solid film states, thereby demonstrating the aggregation‐induced fluorescence changes. Introduction Fluorescent high‐performance polymers have been extensively used in designing optoelectronic devices due to their low cost, excellent thermal stability, high mechanical strength, low flammability, good chemical and radiation resistance, and good electronic properties. While conventional organic luminophores fluoresce strongly in dilute solutions, they suffer from undesirable aggregation‐caused quenching in concentrated solutions and in the solid state due to extensive π‐π stacking interactions and formation of delocalized excitons or excimers. This phenomenon leads to non‐radiative decay thus, decreased fluorescence emission of the material in the solid film state, which significantly limits their real‐world application as solid light‐emitting materials. Objectives To develop new high‐performance polymers with high photo luminescent efficiency, good processability, film‐forming properties, which could potentially be used in the fabrication of optoelectronic devices. Methods The preparation of the polyimide DiCN‐PI was carried out by a one‐step, high‐temperature solution imidization method. In this procedure, 1,2,4,5‐cyclohexanetetracarboxylic dianhydride and the diamine were polymerized in 1‐methyl‐2‐pyrrolidinone and γ‐butyrolactone co‐solvent at 180°C for 15 hours in the presence of isoquinoline as catalyst. On the other hand, polyamide DiCN‐PA was synthesized according to the direct phosphorylation polycondensation technique described by Yamazaki from diamine and trans‐1,4‐cyclohexanedicarboxylic acid using triphenyl phosphite and pyridine as condensing agents. Results and Discussion Both polymers were soluble in several polar aprotic solvents and exhibited useful levels of thermal stability. The polymers were emissive with PL emission bands around 555 (bluish‐green) and 498 (cyan) nm in dilute 1‐methyl‐2‐pyrrolidinone solutions for polyimide and polyamide, respectively. In the solid film state, the polymers emit light green and yellow colors, which simulate the PL behavior of their aggregated states, thereby demonstrating aggregation‐induced fluorescence changes. Conclusions These results indicate that the incorporation of bulky dicyanoarylamine moiety and alicyclic monomer units into the rigid polymer backbones effectively disrupted the planarity of the chain packing which resulted to the fluorescent high‐performance polymers with desired properties for potential optoelectronic applications.

Pyrroloquinoline Based Styryl Dyes Doped PMMA, PS, and PS/TiO2 Polymer for Fluorescent Applications

Hyperbranched Polymer Based on Triphenylamine and Pyridine: Fluorescent Chemosensors for Palladium Ions

Novel 1,4-diketo-3,6-diphenyl pyrrolo[3,4-c]pyrrole (DPP)-based copolymers with large Stokes shift

Two-photon Absorption and Mechanofluorochromic Properties of 1,4-Diketo-2,5-dibutyl-3,6-bis(4-(carbazol-n-yl)phenyl)pyrrolo[3,4-c]pyrrole

Dithienopyrrole–quinoxaline/pyridopyrazine donor–acceptor polymers: synthesis and electrochemical, optical, charge-transport, and photovoltaic properties

Synthesis, Electrochemical, Photophysical, and Electroluminescent Properties of Organic Dyes Containing Pyrazolo[3, 4-B]quinoline Chromophore

Highly Luminescent Polymers Containing the 2,3,5,6-Tetraarylated Pyrrolo [3,4-C] Pyrrole-1,4-Dione (N-Aryl Dpp) Chromophore in the Main Chain

9-Anthryl-capped DPP-based Dyes: Aryl Spacing Induced Differential Optical Properties

2,2′-Bipyrimidine as a Building Block for the Design of Emissive Conjugated Polymers for Hybrid LED Lighting

Multiple stimuli-responsive electropolymerized polymer based on quinacridone dye via breaking conjugated structure strategy

Synthesis, characterization, and photophysical properties of dicyanoarylamine‐based semi‐aromatic polymers

Synthesis, Characterization, Electrochemistry and Optical Properties of a Novel Phenanthrenequinone‐ Alt‐dialkylfluorene Conjugated Copolymer

Molecular Design and DFT Analysis of High-performance Dyes Based on Pyrene with Different Donor Parts and Their Optoelectronic Applications

Recent Advances in Applications of Fluorescent Perylenediimide and Perylenemonoimide Dyes in Bioimaging, Photothermal and Photodynamic Therapy

Novel emissive styryl dyes from 9-methoxy anthracene: Synthesis, photophysical, thermal stability, viscosity, and DFT study

Electrochemical and optical properties of poly(4-(4-(1H-pyrrol-1-yl)phenyl)-4H-dithieno[3,2-b:2',3'-d]pyrrole

Synthesis and remarkable mechano- and thermo-hypsochromic luminescence of a new type of DPP-based derivative

Design and Synthesis of Pyrazino[2,3-f][1,10]phenanthroline-Based Color-Tunable Thermally Activated Delayed Fluorescence Emitters: Exploring Novel Molecular Architectures for High-Efficiency Organic Light-Emitting Diodes.

Metal‐Free and Fluorescent Diketopyrrolopyrrole Fluorophores for Dye‐Sensitized Solar Cells

Strategic Approach to Pyrazinoquinoxaline Molecular Design for Enhanced Performance

Synthesis and Fluorescence Study of Conjugated Polymers Based on 2,4,6-Triphenylpyridine Moieties