Abstract:Pennisetum glaucum (PG) is commonly known as "pearl millet". The large amount of lignocelluloses biomass leftover from its harvest was used to make a green adsorbent that can substitute for other, more expensive adsorbents for water treatment. In this report, a novel citric acid (CA)—grafted PG based adsorbent was developed and employed for the efficient adsorption of three cationic dyes Crystal Violet (CV), Fuchsin Basic (FB), and Methylene Blue (MB) from their single and multicomponent systems. The effects of adsorption factors like pH, adsorbent dosage, contact time, and initial concentration of dye solution were studied, and the outcomes indicate that the current adsorbent is very efficient for the removal of cationic dye at neutral pH. Regression analysis revealed that the experimental data was well-suited to the second-order polynomial model with a coefficient of correlation (R 2 ) value of 0.98 and a high Fisher F-value. The signal-to-noise ratio values i.e., 28.90 (CV), 32.75 (FB), and 34.79 (MB) indicate an adequate signal. The p-values for the lack of fit (0.4011 for CV, 0.4631 for FB, and 0.5728 for MB) confirmed the validity of the used models. Pseudo—2nd order and Langmuir isotherm models were the most compatible with the experimental results, giving chemisorptions and monolayer type adsorption with good values of maximum monolayer adsorption efficiency of 279.33, 135.68, and 133.57 mg/g for CV, FB, and MB dyes, respectively. The thermodynamic studies indicate that the negative values of ΔH (kJ/mol) — 16.19 (CV),—23.15 (FB) and—13.87 (MB) show the exothermic adsorption process and the negative value of ΔS (J/molK)—20.89,—48.55,—31.22 for CV, FB and MB dyes indicated that the degree of randomness at the adsorbate-adsorbent interface decreased during adsorption. The cooperative and competitive effects of dyes in multicomponent solutions were studied using the modified Langmuir adsorption isotherm model. The outcome of this study indicates the competitive effect of counter adsorbates on the target dye, and this dye adsorption behavior was deeply explored by adsorption mechanisms. The adsorbent could be regenerated using acetone and hot water solution for up to five adsorption–desorption cycles. The synthesized CA—PG adsorbent has advantages such as ease of synthesis, cost-effectiveness, and being environmentally benign.

Carbon aerogel and polyaniline/carbon aerogel adsorbents for Acid Green 25 dye: synthesis, characterization and an adsorption study

Fabrication of 3D compressible polyaniline/cellulose nanofiber aerogel for highly efficient removal of organic pollutants and its environmental-friendly regeneration by peroxydisulfate process

Adsorption of anionic acid red G dye on polyaniline nanofibers synthesized by FeCl 3 oxidant: Unravelling the role of synthetic conditions

Adsorption Characteristics of Carbon Tetrachloride from Aqueous Solution Onto Polyacrylonitrile-Based Activated Carbon Fiber

Selective adsorption of anionic dyes and carbon dioxide using uncarbonized PVA aerogels incorporated with GO/PANI hybrids

Efficient Decontamination of Cationic Dyes from Synthetic Textile Wastewater Using Poly(acrylic acid) Composite Containing Amino Functionalized Biochar: A Mechanism Kinetic and Isotherm Study

Sustainable and Circular Adsorption of Anionic Dye from Textile Wastewater Using Economical Adsorbent

Adsorptive separation of food and textile dyes from aqueous solution by SBA-15 supported polyaniline/polypyrrole composite: isotherms, kinetics, thermodynamics and recyclability study

Cellulose Nanofibril/Carbon Nanomaterial Hybrid Aerogels for Adsorption Removal of Cationic and Anionic Organic Dyes

Nitrogen-Rich Polyaniline-Based Activated Carbon for Water Treatment: Adsorption Kinetics of Anionic Dye Methyl Orange

Facile synthesis and ultrastrong adsorption of a novel polyacrylamide-modified diatomite/cerium alginate hybrid aerogel for anionic dyes from aqueous environment

Preparation of Bio-Based Aerogel and Its Adsorption Properties for Organic Dyes

Efficient removal of toxic dyes malachite green and fuchsin acid from aqueous solutions using Pullulan/CMC hydrogel.

Preparation of graphene oxide-doped silica aerogel using supercritical method for efficient removal of emerging pollutants from wastewater

Utilization of citric acid functionalized lignocellulosic biomass as a novel adsorbent for efficient removal of cationic dyes in single and multicomponent systems

Treatment of Water Containing Dyes Using Cellulose Aerogels

Highly efficient and selective removal of anionic dyes from aqueous solutions using polyacrylamide/peach gum polysaccharide/attapulgite composite hydrogels with positively charged hybrid network

Flexible fabrication chitosan-polyamidoamine aerogels by one-step method for efficient adsorption and separation of anionic dyes

Wide-Spectrum Dye Adsorption Performance of Alginic Acid Carbon Aerogel

Removal of Methylene Blue Dye from Wastewater Using Polydopamine Agave Americana Fibres-co-Poly(AAc)/Ag Nanocomposites

Preparation of a surface modified fly ash-based geopolymer for removal of an anionic dye: Parameters and adsorption mechanism