Abstract:Zinc (Zn)–manganese dioxide (MnO2) rechargeable batteries have attracted research interest because of high specific theoretical capacity as well as being environmentally friendly, intrinsically safe and low-cost. Liquid electrolytes, such as potassium hydroxide, are historically used in these batteries; however, many failure mechanisms of the Zn–MnO2 battery chemistry result from the use of liquid electrolytes, including the formation of electrochemically inert phases such as hetaerolite (ZnMn2O4) and the promotion of shape change of the Zn electrode. This manuscript reports on the fundamental and commercial results of gel electrolytes for use in rechargeable Zn–MnO2 batteries as an alternative to liquid electrolytes. The manuscript also reports on novel properties of the gelled electrolyte such as limiting the overdischarge of Zn anodes, which is a problem in liquid electrolyte, and finally its use in solar microgrid applications, which is a first in academic literature. Potentiostatic and galvanostatic tests with the optimized gel electrolyte showed higher capacity retention compared to the tests with the liquid electrolyte, suggesting that gel electrolyte helps reduce Mn3+ dissolution and zincate ion migration from the Zn anode, improving reversibility. Cycling tests for commercially sized prismatic cells showed the gel electrolyte had exceptional cycle life, showing 100% capacity retention for >700 cycles at 9.5 Ah and for >300 cycles at 19 Ah, while the 19 Ah prismatic cell with a liquid electrolyte showed discharge capacity degradation at 100th cycle. We also performed overdischarge protection tests, in which a commercialized prismatic cell with the gel electrolyte was discharged to 0 V and achieved stable discharge capacities, while the liquid electrolyte cell showed discharge capacity fade in the first few cycles. Finally, the gel electrolyte batteries were tested under IEC solar off-grid protocol. It was noted that the gelled Zn–MnO2 batteries outperformed the Pb–acid batteries. Additionally, a designed system nameplated at 2 kWh with a 12 V system with 72 prismatic cells was tested with the same protocol, and it has entered its third year of cycling. This suggests that Zn–MnO2 rechargeable batteries with the gel electrolyte will be an ideal candidate for solar microgrid systems and grid storage in general.

Electrochemical Characterization of a Zinc-Based Gel-Polymer Electrolyte and Its Application in Rechargeable Batteries

Zn/Natural graphite rechargeable cell with an ionic liquid based gel polymer electrolyte

Carboxymethyl Cellulose – Polyvinyl Alcohol Composite-Based Gel Polymer Electrolyte for Rechargeable Zn-Air Batteries

High electrochemical and mechanical performance of zinc conducting-based gel polymer electrolytes

Performance of Thixotropic Gel Electrolytes in the Rechargeable Aqueous Zn/LiMn2O4 Battery

Physicochemical, Electrochemical, and Spectroscopic Characterization of Zinc-Based Room-Temperature Molten Electrolytes and Their Application in Rechargeable Batteries

Protic ionic liquid-based gel polymer electrolyte: structural and ion transport studies and its application in proton battery

Hydroxyl Conducting Hydrogels Enable Low-Maintenance Commercially Sized Rechargeable Zn–MnO2 Batteries for Use in Solar Microgrids

A Rechargeable Zn–Air Battery with High Energy Efficiency and Long Life Enabled by a Highly Water‐Retentive Gel Electrolyte with Reaction Modifier

Enhancing the Kinetics of Zinc Ion Deposition by Catalytic Ion in Polymer Electrolytes for Advanced Zn–MnO2 Batteries

Plastic crystal-incorporated magnesium ion conducting gel polymer electrolyte for battery application

Gel Electrolyte Constructing Zn (002) Deposition Crystal Plane Toward Highly Stable Zn Anode

Tailoring codirectional Zn 2+ pathways with biomaterials for advanced hydrogel electrolytes in High-Performance zinc metal batteries

Cathode|Electrolyte Interface Engineering by a Hydrogel Polymer Electrolyte for a 3D Porous High‐Voltage Cathode Material in a Quasi‐Solid‐State Zinc Metal Battery by In Situ Polymerization

A Ternary Cross-linked Gel Electrolyte with High Mechanical Strength and Ionic Conductivity for Ultra-long-life Reversible Zinc Deposition

Phosphonated graphene oxide-modified polyacrylamide hydrogel electrolytes for solid-state zinc-ion batteries

High‐Current Capable and Non‐Flammable Protic Organic Electrolyte for Rechargeable Zn Batteries

Gel Polymer Electrolyte toward Large‐Scale Application of Aqueous Zinc Batteries

The critical role of in-situ lithium fluoride in gel polymer electrolyte for high-performance rechargeable batteries

Ti 3 C 2 T x Filled in EMIMBF 4 Semi-Solid Polymer Electrolytes for the Zinc-Metal Battery

Polyvinyl Alcohol-Based Gel Electrolytes with High Water Content for Flexible Zinc-Air Batteries with High Rate Capability