Abstract:The use of nanoparticles (NPs) as reinforcements in polymeric coatings allows for direct interaction with the polymeric chains of the matrix, resulting in a synergistic process through physical (electrostatic forces) and chemical interactions (bond formation) for the improvement of the mechanical properties with relatively low weight concentrations of the NPs. In this investigation, different nanocomposite polymers were synthesized from the crosslinking reaction of the hydroxy-terminated polydimethylsiloxane elastomer. Different concentrations (0, 2, 4, 8, and 10 wt%) of TiO2 and SiO2 nanoparticles synthesized by the sol-gel method were added as reinforcing structures. The crystalline and morphological properties of the nanoparticles were determined through X-ray diffraction (XRD), Raman spectroscopy, and transmission electron microscopy (TEM). The molecular structure of coatings was through infrared spectroscopy (IR). The crosslinking, efficiency, hydrophobicity, and adhesion degree of the study groups were evaluated with gravimetric crosslinking tests, contact angle, and adhesion tests. It was observed that the crosslinking efficiency and surface adhesion properties of the different nanocomposites obtained were maintained. A slight increase in the contact angle was observed for the nanocomposites with 8 wt% compared to the polymer without reinforcements. The mechanical tests of indentation hardness and tensile strength following the ASTM E-384 and ISO 527 standards, respectively, were performed. As the nanoparticle concentration increased, a maximum increase of 157% in Vickers hardness, 71.4% in elastic modulus, and 80% in tensile strength was observed. However, the maximum elongation remained between 60 and 75%, ensuring that the composites did not become brittle.

Elaboration and influence of annealing process on physico-chemical properties of silica–titania nanocomposites

Influence of Annealing Temperature on Microstructure and Phase Transformations of Oxide System Bi2O3/TiO2 Formed in Aqueous Solutions

Effect of Annealing on the Microstructure and Magnetic Properties of Fe-based Nanocomposite Materials

Temperature annealing and aluminum atomic concentration effect on structural, morphological and optical properties of ZnO-Al2O3 nanocomposites powders and photocatalytic performances

Study of Annealing Effect Upon the Structural and Solar- Selective Properties of C/Ni/NiO Composite Coatings Prepared by Sol–gel Method

Influence of annealing on microstructures and photoluminescence of nano-composite silicon film

Effect of Mg and Cu co-doping on nanostructured TiO2 photocatalytic activity

Annealing Effects on the Structural, Positron Annihilation Parameters, and Electrical Properties of Fe2O3- PbO2-TeO2 Glasses

Annealing-induced enhancement of TiO 2 -ZnO nanocomposites for high-performance room-temperature air pollutant detection in fiber optic sensors

Thermal evolution of morphological, optical, and photocatalytic properties of Au–Cu2O–CuO nanocomposite thin film

Effect of Embedded-Silica on Microstructure and Photocatalytic Activity of Titania Prepared by Ultrasound-Assisted Hydrolysis

Effect of annealing temperature on the physical of nanostructured TiO2 films prepared by sol-gel method

Effect of Annealing Temperature on Structural Phase Transformations and Band Gap Reduction for Photocatalytic Activity of Mesopores TiO2 Nanocatalysts

Silica-coating-assisted nitridation of TiO2 nanoparticles and their photothermal property

Ellipsometric Study of the Optical Properties of Silicon-Based Si : Sio2 Composite Thin Films under Different Annealing Temperatures

Effect of Annealing Temperature on TiO2 Nanostructured Prepared by Sol-Gel Method

Effect of annealing temperature of titanium dioxide thin films on structural and electrical properties

PDMS/TiO2 and PDMS/SiO2 Nanocomposites: Mechanical Properties' Evaluation for Improved Insulating Coatings

The effect of stoichiometric ratio of Mg/SiO2 and annealing on physical properties of silicon nanoparticles by magnesium-thermic chemical reduction process using the SiO2 precursor

Preparation and Investigation of Sol–Gel TiO2-NiO Films: Structural, Optical and Electrochromic Properties

Influence of annealing temperature and laser irradiation on the structural, optical, and photoluminescence characteristics of Ni2O3/SnO2 nanocomposites for perspective applications