Abstract:Chemical dyes used in the textile industries are one of the major pollutants in water. Methylene blue (MB) is a commonly seen dye that creates hazardous health problems. In this article the photocatalytic degradation of MB by the nanocatalyst MoS 2 (Nano-MoS 2 ) and carbon dot (C Dots) incorporated MoS 2 (Nano-CD-MoS 2 ) is reported. The photocatalytic degradation of MB is analyzed based on the electron-hole recombination rate of the catalyst. Photoluminescence emission exhibited by the catalyst is used as a key indicator to probe the electron-hole recombination rate. Nano-MoS 2 was synthesized hydrothermally at 180 0 C for 8 h from ammonium tetra thiomolybdate (ATTM). C Dot was prepared following a green root from ash guard extract which later mixed with Nano-MoS 2 and kept in an autoclave at a temperature 140 °C for 4 h to get Nano-CD-MoS 2 . The photoluminescence (PL) and photocatalytic behavior of Nano-MoS 2 and Nano-CD-MoS 2 and their application for water splitting and water purification are reported. The incorporation of graphene and artificial C Dot into MoS 2 nanostructures are reported to increase the conductivity and active edge sites of MoS 2 that enhances the photocatalytic action. Since green C Dots are eco-friendly and easily synthesizable than artificial C Dots, as a novel study, this article investigated the influence of green C Dots on the PL and photocatalytic performance of nanosized MoS 2 . Nano-MoS 2 and Nano-CD-MoS 2 exhibited both upconversion and downconversion PL; accordingly the nanostructures were termed as amphi -luminescent. The amphi -luminescence property widens the photon absorption range and hence enhances the catalytic degradation of dyes. Nano-MoS 2 which exhibited lesser intensity of amphi -luminescence emission compared to Nano-CD-MoS 2 showed better results in degradation of MB. C Dots may bind with the valence band electrons of MoS 2 , resulting in the reduction of dangling bonds Dangling bonds can trap photo-induced excitons to hinder the rate of electron-hole recombination. So, fast electron-hole recombination occurs in Nano-CD-MoS 2 than Nano-MoS 2 . Fast electron-hole recombination supports radiative electron-hole recombination while suppresses the non-radiative energy transfer of electrons and causes high PL intensity. However, according to the energy level diagram, Nano-MoS 2 with minimal electron-hole recombination rate is more favorable for O 2 /O 2 – ,OH/ OH – andOH/H 2 O reactions that facilitate MB degradation. Photocatalytic activity of catalysts were confirmed by measuring the photocurrent from a simple custom-made two-electrode water photolysis cell where the nanocatalysts were dispersed in electrolyte. Lead and steel rods were used as electrodes. Multimeter was used to measure current. Nano-MoS 2 exhibited better performance with a maximum photocurrent of 141 μA. Influence of green C Dots in energy levels, PL and photocatalysis of MoS 2 and mechanisms of PL and degradation of MB are thoroughly investigated in this article.

Two-dimensional β-In 2 S 3 Nanosheets-MoS 2 Nanoflowers Heterostructures: A Novel Sunlight-induced Photocatalyst for Pollutant Removal in Water

Enhanced sunlight driven photocatalytic activity of In2S3 nanosheets functionalized MoS2 nanoflowers heterostructures

MoS2 nanoflowers functionalized with C3N4 nanosheets for enhanced photodecomposition

Enhanced Photocatalytic Degradation of Cr (VI) and Organic Pollutants Using Novel 3D/2D MoS 2 /SnS 2 Heterostructures for Water Remediation

Rational design 2D/3D MoS2/In2O3 composites for great boosting photocatalytic H2 production coupled with dye degradation

Direct 2D/2D Z-scheme SnNb2O6/ZnO Hybrid Photocatalyst with Enhanced Interfacial Charge Separation and High Efficiency for Pollutants Degradation

Non-noble metal ultrathin MoS2 nanosheets modified Mn0.2Cd0.8S heterostructures for efficient photocatalytic H2 evolution with visible light irradiation

Novel MoS2-In2O3-WS2 (2D/3D/2D) ternary heterostructure nanocomposite material: Efficient photocatalytic degradation of antimicrobial agents under visible-light

Role of Two-Dimensional Nanointerfaces in Enhancing the Photocatalytic Performance of 2D-2D MoS2/CdS Photocatalysts for H2 Production

Mos2 Nanosheet-Modified Cuins2 Photocatalyst for Visible Light-Driven Hydrogen Production from Water

Hierarchical TiO2 nanostructures sensitized with MoS2 nanosheets: An efficient and reusable heterojunction photocatalyst for sunlight-assisted degradation of organic dye pollutants

Amphi-Luminescent MoS 2 nanostructure for photocatalytic splitting of water and removal of Methylene Blue

In situ growth of semiconducting 1T/3R-MoS 2 nanosheets on spindle Mil88a as a novel heterostructure for outstanding photocatalytic performance

High efficiency photocatalysis for pollutant degradation with MoS2/C3N4 heterostructures

Investigating the effect of MoS2–SnS2 heterojunction to enhance the decomposition of organic pollutants under visible light irradiation

Ultrafine MoS 2 /Sb 2 S 3 Nanorod Type‐II Heterojunction for Hydrogen Production under Simulated Sunlight

In suit constructing 2D/1D MgIn2S4/CdS heterojunction system with enhanced photocatalytic activity towards treatment of wastewater and H2 production

Integrating MoS2 on Sulfur-Doped Porous G-C3n4 Iostype Heterojunction Hybrids Enhances Visible- Light Photocatalytic Performance

Constructing noble-metal-free 0D/2D CdS/SnS2 heterojunction for efficient visible-light-driven photocatalytic pollutant degradation and hydrogen generation

Interface engineering of a noble-metal-free 2D–2D MoS2/Cu-ZnIn2S4 photocatalyst for enhanced photocatalytic H2 production

Facile Construction of a Molybdenum Disulphide/zinc Oxide Nanosheet Hybrid for an Advanced Photocatalyst