Abstract:Graphene Oxide has shown outstanding performance in the application of adsorption, but these adsorbents are still limited due to some factors. Assembling 2-dimensional (2D) nanomaterials into 3-dimensional (3D) macrostructure (microbead, hydrogel, aerogel, sponge) is a promising alternative to solve the limitation. This paper embedded GO into the two natural polysaccharide polymers (agarose and sodium alginate) to form a 3D-adsorbent. GO-Alg and GO-Agar microbeads were synthesized using the crosslinking method. Analysis techniques such as FT-IR, FESEM-EDX, XRD, and zeta potential were used to characterize the GO-containing microbeads. Adsorption parameters such as adsorbent dosage, pH, contact time, initial ion concentration, and temperature were optimized. Langmuir isotherm and pseudo-first-order kinetic model well fit into the experiment data. The maximum adsorption capacity (qmax) obtained was 120.37 mg.g−1 for removing methylene blue solution. Thermodynamic parameters such as ∆G˚, ∆H˚, and ∆S˚ were determined, and the process was considered endothermic and spontaneous. Reusability results showed good regeneration of GO-Alg microbead up to eight consecutive adsorption-desorption cycles without a significant drop in removal efficiency (> 96%). The application of GO-Alg microbead for MB removal on a packed-bed reactor was investigated in different experimental conditions, and 1 mL.min−1 flow rate with 15 cm bed height revealed a better result. The application of fluidized-bed adsorption was performed to solve the limitation of packed-bed adsorption, and the result showed better adsorption performance than packed-bed using the same operating condition.

Adsorption and release on three-dimensional graphene oxide network structures

Preparation and characterization of 3D graphene oxide nanostructures embedded with nanocomplexes of chitosan- gum Arabic biopolymers

Probing structural variations of graphene oxide and reduced graphene oxide using methylene blue adsorption method

The effective adsorption and decomposition of N2O on Al-decorated graphene oxide under electric field

Enhanced adsorption of acidic gases (CO2, NO2 and SO2) on light metal decorated graphene oxide.

Dye Adsorption on Electrochemical Exfoliated Graphene Oxide Nanosheets: Ph Influence, Kinetics and Equilibrium in Aqueous Solution

Novel Adsorbent of N -Phenylthiourea-Functionalized Graphene Oxide and Its Removal of Methyl Orange in Aqueous Solutions

Extraordinary water adsorption characteristics of graphene oxide

Staggered structural dynamic-mediated selective adsorption of H2O/D2O on flexible graphene oxide nanosheets

Fabrication of 3D hierarchical networks adsorbent immobilized MoS 2 for adsorption of Ag(I) from aqueous solution

Novel Adsorbent of <i>N</i>-Phenylthiourea-Functionalized Graphene Oxide and Its Removal of Methyl Orange in Aqueous Solutions

A simple method for floating graphene oxide films facilitates nanoscale investigations of ion and water adsorption

Structural Properties of Graphene Oxide Prepared from Graphite by Three Different Methods and the Effect on Removal of Cr(VI) from Aqueous Solution

Synergistic effects of 2D graphene oxide nanosheets and 1D carbon nanotubes in the constructed 3D carbon aerogel for high performance pollutant removal

Influence of the Surface Structure of Graphene Oxide on the Adsorption of Aromatic Organic Compounds from Water.

Charge-driven interaction for adsorptive removal of organic dyes using ionic liquid-modified graphene oxide

Efficient adsorption of anionic and cationic dyes by PVA/PAA/GO composite hydrogel with three-dimensional porous double network structure

Immobilization of graphene oxide into microbead for fluidized-bed adsorption of methylene blue

Adsorption Of Polycyclic Aromatic Hydrocarbons By Graphene And Graphene Oxide Nanosheets

Organic dye sequestration using Graphene Oxide–Activated Carbon (GOAC) composite unaided by linker molecule

Graphene oxide-induced structural morphology and colloidal interaction at water–oil interface