Abstract:Hexagonal ferrites of M -type (in particular, BaFe 12 O 19 ) are magnetic materials with functional characteristics affected both by chemical composition and technology of their synthesis. We present the results of studying the magnetic and structural properties of BaFe 12 – x Cu x O 19 hexaferrites ( x = 0, 0.1, 0.2, 0.3, 0.4) obtained by hydrothermal synthesis with partial substitution of copper for iron. The composition of the synthesized samples was analyzed using X-ray diffraction, and the magnetic characteristics were measured using a vibration magnetometer. It has been revealed that the coercivity of the ferrite powders depends non-monotonically on the copper concentration and reaches the maximum (5629 Oe) and minimum (4698 Oe) values at x = 0 and x = 0.2. The presence of copper reduces the coercive force, but at the same time the values remain rather high compared to the results of similar studies. The saturation magnetization of the obtained ferrites gradually decreases (from 65.88 to 60.75 A · m 2 /kg at x = 0 and x = 0.4, respectively) with increasing. The distribution of Cu over ferrite sublattices was studied using Mössbauer spectroscopy. It is shown that in the hexaferrite structure, copper ions preferentially occupy 12 k and 4 f 1 sites. Hence, a decrease in the saturation magnetization with increasing x is most likely attributed to the presence of side non-magnetic phases observed on X-ray diffraction patterns. It is also revealed that during synthesis, copper participates in the formation of low-melting phases on the surface of hexaferrite grains which promotes agglomeration of the particles. Thus, the resulting powders can potentially be sintered at lower temperatures and, therefore, without a significant increase in the size of crystallites. Herewith, the coercivity retains its original high values. The results obtained can be used in developing ferrite permanent magnets with improved characteristics.

Ferrimagnetic copper chloride hydroxide

Hybrid Chalcopyrite-Polymer Magnetoconducting Materials

Effect of Copper Substitution on the Dielectric and Magnetic Properties of Low-Temperature-Sintered Z-type Ferrites

Mott-Kondo Insulator Behavior in the Iron Oxychalcogenides

Discovery of New Ferroelectrics: [H<sub>2</sub>dbco]<sub>2</sub>·[Cl<sub>3</sub>]·[CuCl<sub>3</sub>(H<sub>2</sub>O)<sub>2</sub>]·H<sub>2</sub>O (dbco = 1,4-Diaza-bicyclo[2.2.2]octane)

Discovery Of New Ferroelectrics: [H(2)Dbco](2)Center Dot[Cl-3]Center Dot[Cucl3(H2o)(2)]Center Dot H2o (Dbco=1,4-Diaza-Bicyclo[2.2.2]Octane)

A Percolative Ferromagnetic—Ferroelectric Composite with Significant Dielectric and Magnetic Properties.

Enhanced Room Temperature Ferromagnetism in Cobalt-Doped Copper Oxide Nanoparticles: Synthesis and Characterization

Effect of Zn Substitution on Morphology and Magnetic Properties of Cufe2o4 Nanofibers

Magnetic properties of Cu, Zn-modified Co2Y hexaferrites

Discovery of new ferroelectrics: [H2dbco]2 x [Cl3] x [CuCl3(H2O)2] x H2O (dbco = 1,4-Diaza-bicyclo[2.2.2]octane).

Low-temperature sintering and electromagnetic properties of copper-modified Z-type hexaferrite

Study of the magnetic and structural properties of BaFe12 – xCuxO19 ferrites obtained by hydrothermal synthesis

Ferromagnetism in Mn-doped CuO

Observation of Ferromagnetic Correlation in Phase-Separated Cu-rich La2CuO4.003

Magnetic Properties of Nanostructured Cufe2o4

Advancements in multiferroic, dielectric, and impedance properties of copper-yttrium co-doped cobalt ferrite for hydroelectric cell applications

Multiferroicity and hydrogen-bond ordering in (C2H5NH3)2CuCl4 featuring dominant ferromagnetic interactions

Magnetic properties in a partially oxidized nanocomposite of Cu-CuCl

Electric, dielectric and phonon properties of Cu 2 OCl 2

Ferromagnetic and insulating behavior in both half magnetic levitation and non-levitation LK-99 like samples